Results 1 to 2 of 2
-
07-04-2007, 07:45 AM #1
help me how to install bilge pump on gp1200r-02
i hawe blown one piston probably water in carburator where do i mount the pump and wiring it and lead water outlet have you pictures?
-
07-04-2007, 10:01 AM #2
* I mounted mine just under the driveshaft coupler on the flat spot of the hull.
* Scuff the hull with sandpaper and clena well with acetone or alcohol
* Wire in a waterproof toggle switch and mount somewhere on your boat for easy access. i.e.) glove box, side of cowling, near battery box ect.....
* Route the water exit somewhere behind the boat. i.e.) under grabrail, rear side of upper hull ect...
*
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
How to remove fuel pump on fzr to install r&d fpr
By XRIDER in forum Yamaha PWC Performance (4-stroke)Replies: 22Last Post: 04-25-2010, 01:30 PM -
How to remove fuel pump on fzr to install r&d fpr
By XRIDER in forum Yamaha Open DiscussionReplies: 1Last Post: 04-17-2010, 01:25 PM -
How to: Install Rad4 seal on RXT, RXT-X, GTX
By Gus13letter in forum Sea Doo How To & FAQsReplies: 20Last Post: 03-23-2010, 12:18 AM -
How to: Install Rad4 seal on RXT, RXT-X, GTX
By Gus13letter in forum 4-Tec PerformanceReplies: 12Last Post: 08-17-2009, 06:14 AM -
What location are people installing bilge pumps on X4 hulls?
By caliburst in forum 2-Stroke PerformanceReplies: 26Last Post: 06-11-2009, 09:18 AM
Any suggestions appreciated. Running injector cleaner and doing spark...
2014 310x bog full throttle off...