Results 1 to 6 of 6
Thread: Beerdart
-
07-01-2007, 02:01 PM #1
- Join Date
- Jan 2007
- Posts
- 25
Beerdart
I found a 3' 20mm cold rolled how much do I have to turn down on the end for the engine. thanks Steve
-
07-01-2007, 02:34 PM #2
-
07-01-2007, 06:47 PM #3
- Join Date
- Jan 2007
- Posts
- 25
Thanks
Steve
-
07-02-2007, 05:59 PM #4
would these measurements have anything to do with the engine alignment tool? if not do you have measurements for that?
-
07-02-2007, 06:10 PM #5
-
07-02-2007, 06:21 PM #6
- Join Date
- Aug 2006
- Location
- Mpls. Mn.
- Posts
- 2,264
- +1
- 20
Overall length 33" with an O.D. of 0.787"...there is a 3" long smaller diameter on one end with an O.D. of 0.710" (this end goes into the engine coupler).
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Beerdart Rocks!!!!
By goBENGALS in forum Polaris Open DiscussionReplies: 16Last Post: 06-08-2007, 10:46 AM -
F/A's From beerdart A+++++++++++++++
By ph2ocraft in forum Polaris Open DiscussionReplies: 16Last Post: 05-09-2007, 06:03 AM -
Pics for Beerdart
By xlint89 in forum Polaris Open DiscussionReplies: 31Last Post: 04-07-2007, 10:07 AM -
Beerdart
By ugadawg131 in forum Polaris Open DiscussionReplies: 7Last Post: 12-16-2006, 01:30 PM -
BeerDart caught paying for Trim!
By ZMANN in forum Polaris PWC PerformanceReplies: 21Last Post: 11-30-2006, 01:24 AM
It is possible the jet pump has seized, preventing the engine from...
2009 FZS Starter Not Turning Engine