Results 1 to 4 of 4
Thread: Thinking of Running Pre-Mix
-
06-26-2007, 05:03 PM #1
Thinking of Running Pre-Mix
Im thinking of running pre-mix in my 96 SL780 and
I was wondering how do I convert it? and
what ratio should I use?
-
06-26-2007, 05:12 PM #2
The stock ratio is 40:1. All you need to do is block off oil lines going to carbs, remove oil pump and shaft, and install bloock off plate.
-
06-26-2007, 10:59 PM #3
Just remember to use an RTV gasket sealant on the block off plate. I use permatex 252. Works great, an btw most of use hear run pre-mix
-
06-26-2007, 11:02 PM #4
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
How to tell if my GP1200R is running Pre-Mix or why this is happened
By SuperCharged67 in forum Yamaha PWC Performance (4-stroke)Replies: 5Last Post: 06-17-2013, 03:58 PM -
ok im stumped. tried everything i can think of and ski still wont run right
By hypersniper2010 in forum 2-Stroke PerformanceReplies: 1Last Post: 08-14-2011, 09:10 AM -
Running pre-mix on 951's????
By OutlawGPR in forum 2-Stroke PerformanceReplies: 3Last Post: 07-20-2009, 06:01 PM -
’95, SL 750-Pre-Mix, gobs of fuel in engine-no start
By dorf in forum Polaris How To & FAQsReplies: 5Last Post: 08-09-2008, 11:18 AM -
How to run an ultra 150 on pre mix
By aruba yamaha in forum Kawasaki PWC Performance (2-stroke)Replies: 2Last Post: 05-08-2008, 05:08 PM
Just tried with the hotter plug today, no change at all. But I think the...
Yamaha FX Cruiser 2005 (FX140),...