Results 1 to 4 of 4
  1. #1
    mittens's Avatar
    Join Date
    Mar 2018
    Location
    Huntsville, AL
    Posts
    1,330
    +1
    148

    Pump Bearing questions

    So I have had the pump out on all my skis, and removed the cone to hold for clutch before I had the tool.

    But I have never redone a pump bearing. I have re done a mid bearing so no issue there.

    Skis has 68 ish hours on it. So what maintenance should I do while I have it out? swapping props and stuff. I have been over a lot of the ski with turbo install motor, and lines and stuff, ride plates and stuff. but figure should check/ maintain the pump.

  2. #2
    Kristian Keppel Waterholics's Avatar
    Join Date
    Apr 2010
    Location
    Florida
    Posts
    1,444
    +1
    43
    Quote Originally Posted by mittens View Post
    So I have had the pump out on all my skis, and removed the cone to hold for clutch before I had the tool.

    But I have never redone a pump bearing. I have re done a mid bearing so no issue there.

    Skis has 68 ish hours on it. So what maintenance should I do while I have it out? swapping props and stuff. I have been over a lot of the ski with turbo install motor, and lines and stuff, ride plates and stuff. but figure should check/ maintain the pump.
    Pump bearings usually dont go bad that often unless there is water intrusion from the cone or the seal by the prop.

    If you opened it and there was no water just re grease and your good to go.


  3. #3
    mittens's Avatar
    Join Date
    Mar 2018
    Location
    Huntsville, AL
    Posts
    1,330
    +1
    148
    Roger that is it feels smooth, and grease under cone looks good, let it ride.

  4. #4
    Reaper9789's Avatar
    Join Date
    Jul 2014
    Location
    Canyon Lake, TX
    Posts
    822
    +1
    109
    The brp triple guard is probably one of the best greases you can put in there. (same stuff they used on johnson outboards forever)

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Rebuilding my 1st pump & need help with bearing race, broken bearing on Ultra 130 150
    By wowchad in forum Kawasaki PWC Performance (2-stroke)
    Replies: 4
    Last Post: 08-05-2021, 07:40 AM
  2. 1993 Polaris 750, jet pump ‘bearing’ configuration questions
    By christianfreiss in forum Polaris Open Discussion
    Replies: 19
    Last Post: 08-08-2020, 08:52 PM
  3. 15F Pump Bearing Install Concerns/Questions
    By kawa900stx in forum Kawasaki PWC Performance (4-stroke)
    Replies: 1
    Last Post: 07-23-2013, 08:33 AM
  4. Pump bearing and setup questions
    By Mark S in forum 4-Tec Performance
    Replies: 5
    Last Post: 03-08-2011, 05:35 PM
  5. Pump Mods Double Bearing/Tripple Bearing
    By Sunfunzoom in forum 4-Tec Performance
    Replies: 24
    Last Post: 02-13-2006, 06:28 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •