Results 1 to 3 of 3
Thread: How to hotwire RXP?
-
06-23-2007, 05:05 PM #1
- Join Date
- Sep 2006
- Location
- Smith Lake, AL
- Posts
- 18
How to hotwire RXP?
My 07 RXPs starter switch has gone out at my house and the ramp is far away and its only me here and I don't think I can pull it back onto the dock ramp. Is there a way I can hotwire this thing to atleast pull it back up?
-
06-23-2007, 06:39 PM #2
uhm.....you need the DESS lanyard.
pluys, I don't think it will be condusive to post "how-to" hotwire a PWC that has a security system built in.
just my .02
-
06-23-2007, 08:51 PM #3
if you are talking about the red "start/stop" buttom going bad then yes...its a simple open/closed setup....cut the wires & touch together until motor starts...touch again to stop.....if your DESS post is bad you are SOL
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
How To: 2008 RXP/RXT Storage Cover Shock Bracket Location Service Bulletin
By jpt7779 in forum Sea Doo How To & FAQsReplies: 19Last Post: 04-05-2018, 10:50 AM -
How to adjust RXP-X 260 A.E.S ??
By Evolol in forum 4-Tec PerformanceReplies: 23Last Post: 09-27-2014, 07:42 PM -
How to winterize RXP-X (with the extrenal intercooler)
By iceman1998 in forum 4-Tec PerformanceReplies: 2Last Post: 10-10-2010, 09:18 PM -
How To: 2008 RXP/RXT Storage Cover Shock Bracket Location Service Bulletin
By jpt7779 in forum 4-Tec PerformanceReplies: 7Last Post: 09-09-2009, 04:24 PM -
How to make RXP handle better
By wakeborder556 in forum Sea Doo Open DiscussionReplies: 15Last Post: 02-14-2006, 03:52 PM
[QUOTE=ShawnInFL;3174396]Was looking at the AEM myself. Any concerns about...
Riva Fuel Rail - Remove Gauge as...