Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12
  1. #11
    I just did mine and and it was actually a lot deeper than I thought. U know you are through when when it finally does go through. I don’t think you could mess it up. The little restriction hole suddenly becomes large. Also I didn’t use a 1/8 as it didn’t fit right in the hole. I went 1 size smaller to fit exactly into the hole. Runs fine besides this other stupid issue with the power valves that’ I’m having.


  2. #12
    dockwalker's Avatar
    Join Date
    Mar 2010
    Location
    On the water near Belhaven,NC
    Posts
    376
    +1
    21
    Just a hint for anyone doing the return modification.Insert a small wooden dowel in the nipple.When the wood chips show while drilling, you'll know you are deep enough.

Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Drilled return depth
    By dockwalker in forum Yamaha How To & FAQs
    Replies: 0
    Last Post: 09-21-2021, 09:24 AM
  2. Replies: 105
    Last Post: 05-25-2021, 12:21 PM
  3. Hard start, choke, accel pump removed, drilled return
    By Jaugi in forum Yamaha PWC Performance (2-stroke)
    Replies: 14
    Last Post: 04-09-2020, 12:55 PM
  4. Drilled return mod xlt1200 info
    By mattc8821 in forum Yamaha PWC Performance (2-stroke)
    Replies: 5
    Last Post: 07-20-2017, 08:15 AM
  5. drilled return mod xlt 1200 question
    By taytay22 in forum Yamaha PWC Performance (2-stroke)
    Replies: 5
    Last Post: 04-13-2017, 09:01 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •