Results 1 to 4 of 4
Thread: oil pump install question
-
06-22-2007, 06:38 PM #1
oil pump install question
is there any reason to adjust the oil pump after removing and reinstalling it? I did not disconnect the lines or cable. ( it looks like a pain to adjjust) thanks
-
06-22-2007, 06:42 PM #2
Need to make sure the lines line up. Better safe than sorry. We all know what happens when a motor doesn't get enough oil.
-
06-22-2007, 07:58 PM #3
what do you maen 'the lines line up'
-
06-25-2007, 04:07 AM #4
- Join Date
- Jul 2006
- Posts
- 1,269
- +1
- 2
If you didnt disconnect the cable you should be fine. I would go ahead and loosen the bleed srew for a minute and verify oil comes out just to make sure there isnt any air in it (just as a precaution).
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
RXP bilge pump install question
By sea-one in forum Sea Doo Open DiscussionReplies: 2Last Post: 11-18-2009, 08:33 PM -
RXP bilge pump install question
By sea-one in forum Open DiscussionReplies: 0Last Post: 11-18-2009, 07:14 PM -
triple outlet pump install question
By Hurban96 in forum Polaris How To & FAQsReplies: 1Last Post: 09-10-2009, 07:41 PM -
Bildge pump install Question??
By crxski in forum Polaris How To & FAQsReplies: 4Last Post: 08-26-2008, 09:45 PM -
Pump install question.
By Mark S in forum 4-Tec PerformanceReplies: 2Last Post: 07-01-2005, 09:25 PM
haha. Don’t activate it. You shouldn’t have an issue getting a refund and...
New SVHO Owner, couple of ?