Results 1 to 2 of 2
  1. #1

    Rod big end diameter

    Anyone know 4tec rod big end diameter without a bearing? I know with bearing its 1.775" but I'm looking for the measurement of a bare rod fully clamped.

    I measured some rods with bearings and they show like 0.002 out of round but when measuring without bearings they're perfectly round. Is it normal for bearings not to form a perfect circle once clamped?


  2. #2

    Join Date
    Sep 2017
    Location
    London UK
    Posts
    262
    +1
    41
    yes that is normal for bearings to be oval as they will pull themselves round while at full load.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. FS Yamaha tr1 bottom end(needs one rod)
    By SELF27 in forum Yamaha Classifieds
    Replies: 3
    Last Post: 12-01-2020, 11:23 AM
  2. Gtx 4tec connecting rod big end clearances
    By mpirpre in forum 4-Tec Performance
    Replies: 11
    Last Post: 01-17-2020, 10:13 PM
  3. WTB - Parts Trim Nozzle Rod End
    By hyoctane23 in forum Polaris Classifieds
    Replies: 1
    Last Post: 07-29-2016, 06:52 AM
  4. 951 big end rod bearing size and suggestions?
    By Daves Doo in forum 2-Stroke Performance
    Replies: 1
    Last Post: 07-16-2014, 03:56 PM
  5. 4-tec rod end-cap ????
    By WHOIS#1 in forum Sea Doo Open Discussion
    Replies: 6
    Last Post: 11-24-2008, 10:29 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •