Looking for 1050 OEM Carburetor Rebuild Kits

[ValleyRacer2]

Hey all - working on my '96 1050 during hard water season. Where's the best place to get OEM carburetor rebuild kits? Thanks!

[Beernutz]

Hey all - working on my '96 1050 during hard water season. Where's the best place to get OEM carburetor rebuild kits? Thanks!

That uses the Keihin CDKII carbs, correct? Watcon carries them here. Yes, they're spendy, but cheaper than buying aftermarket first, then these! They also carry the fuel pump kit, here, and the accelerator pump kit here.

[ValleyRacer2]

Keihin - yes. Only marking I can find are
807-4
495
A31C KL05

So...not sure

[Beernutz]

Have you looked at the PWC Manuals page? It contains the service manual for your SLTX.

I've attached an excerpt from the manual that shows the specs for your 1050.

It appears that it uses the same CDKII carbs, as the rest of the domestic engine line. So the Watcon kits should work for you.

[ValleyRacer2]

Perfect. I have the manual but didn't think to look for the spec there. Thank you. Took out the PTO rod in the fall - crankcase was dry compared to center/mag. Suspect seals or carbs. Rebuilt crank is done - installing OEM seals. Then starting on cylinders and carbs. Simple 2 stroke - right?

[JP44]

If watcon doesn’t have them for you, I stumbled across some on Amazon this summer. Sudco, kit number 025-627, $60. Good luck, I’m getting close on my basement rebuild...getting ready for the leak testing.

[ValleyRacer2]

I am ready to seal up the cases with the rebuilt crank. Slow and steady, heavy on OEM parts this time. May post up a video series start to finish.