Results 1 to 7 of 7
Thread: 2008 RXPX255 Fuel Pump
-
11-23-2020, 06:32 AM #1
2008 RXPX255 Fuel Pump
Have a 2008 RXPX 255 that stopped running. It was hard to start , start then stop a few times and then started and ran long enough to get off the water. Replaced the plugs and coils, had no codes , has no fuel pressure. Pump doesn’t come on at all. Fuses are good. Have power at pin B with ground at pin A on pump. Any ideas before I start to check wires . The ski was running great before this happened.
-
11-23-2020, 03:33 PM #2
Sounds like the fuel pump itself crapped. Not uncommon. Pull it and test it with 12v.
-
+1 by:
-
11-23-2020, 06:08 PM #3
Best would be to get a fuel pressure gauge.
It should be around 3 bars anyway. And check it if after while when pump warm up its not cutting. If its quiet hit a tank with hammer like its commonly used in cars. It should wake a pump for a minute or two. If your behaviour is same its pump inside a tank gives trouble and you need new one.
Or as it was said you can remove it, but it might work under a power supply, but wouldnt be working with resistance on it.
Fuel pressure gauge are cheap enough these days. And you can try to find one with connectors similar to fuel line.
Good luck with fixing.
-
11-23-2020, 10:07 PM #4
I have an inline fuel pressure gauge. It’s reads 0 psi. The fuel pump is new. Cleaning all the grounds now and replacing the TOP switch
-
11-24-2020, 07:07 AM #5
Is the power comming to the pump plug? Its straight forward.
Do you have buds or any other diag? You can activate fuel pump as far as I remember.
Small hint. If youll be using a needle pin to check voltage thru wire sealing use liquid seal in this place to seal wire again. If you wont ( or someone didnt done it few years back) now wire will be coroded a lot. Itll save you strange problems in the future.
-
11-26-2020, 08:46 PM #6
All wires have power and ground. Can not turn on fuel pump with software. ECM is bad
On back order with SeaDoo until 12/22
-
12-19-2020, 08:09 AM #7
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
should I use a 83mm or 87mm nozzle with stage1 riva 2008 rxpx255
By Dougsand12@gmail.com in forum 4-Tec PerformanceReplies: 7Last Post: 09-27-2019, 07:53 AM -
2008 rxpx255 fault code p0546
By james747 in forum 4-Tec PerformanceReplies: 6Last Post: 11-22-2018, 11:56 AM -
WTB - Parts 2008 Fuel Pump Assembly
By Slow 91 in forum Sea Doo ClassifiedsReplies: 1Last Post: 03-24-2014, 08:37 AM -
2008 rxpx255 comparison
By james747 in forum 4-Tec PerformanceReplies: 6Last Post: 02-17-2014, 06:21 PM -
FS: 2008 RXP fuel pump
By Hydrotoys in forum Sea Doo ClassifiedsReplies: 2Last Post: 04-02-2009, 03:31 PM
Yeah. He doesn't wanna mess with a fpr or watching the wideband.
Demodding 2004 rxp