Prop not catching shaft

[Chug1106]

Hope these
pictures upload

[Chug1106]

[Chug1106]

[K447]

Hope these
pictures upload

Photos not showing in last two posts.

Are you using the greenhulk.net web site directly or an app?

[Chug1106]

[Chug1106]

Doing on the web on I phone . Didn’t know there was an app , will get that

[Chug1106]

[jpt7779]

I see the following issues:

1. Drive shaft splines are stripped.
2. Impeller nose cone became loose causing marks on drive shaft.
3. Impeller splines are stripped.

Engine to pump alignment is most probably not correct, engine is most likely sitting too far forward (longitudinal axis). All 3 engine mounts need to be checked for damage.

Driveshaft, bellows, c-clip, carbon ring, floating ring, PTO bearing seal, and impeller needs to be replaced. Engine mounts closely checked. Alignment definitely needs to be accomplished.