GP1200R Advent CDI

[Jonesyfxr]

So we just picked up an Advent 1290 CDI for our GP1200R.
We are new to these, so I am looking for some suggestions to set up the ski. Any help is appreciated.
Thanks

[MalinTas]

Hi ,
mine has the curves written on it that are programmed . Do you know what curves/curve set is on it?
Regards mal

[Jonesyfxr]

Hi ,
mine has the curves written on it that are programmed . Do you know what curves/curve set is on it?
Regards mal

That's the thing.... I see there aren't curves written on it. I spoke to the seller and he is not sure either.

[Adam]

What sticker is on the side of it ? You can tell what curves it was programmed with on the Advent web site . I have just purchased another 1290 CDI too for my second GP1200R , I too will check which curves it has as its a RIVA branded unit .

[Jonesyfxr]

What sticker is on the side of it ? You can tell what curves it was programmed with on the Advent web site . I have just purchased another 1290 CDI too for my second GP1200R , I too will check which curves it has as its a RIVA branded unit .

Thanks dude!!!
We will be receiving the unit on Saturday. I will take a look and keep you posted.

[Jonesyfxr]

Adam..... so if I’m reading the website correctly, the letters to the far left dictate the curves installed to the right??

[Jonesyfxr]

Thanks Adam.... we have D60 programming

[Adam]

Yam 84 is best in my opinion, use good fuel and you will be very happy.

[Jonesyfxr]

Yam 84 is best in my opinion, use good fuel and you will be very happy.

What mods are done to your ski?
So far we have Jetworks mod, angled R&D ride plate and, R&D 800 intake grate, PROX S/A’s, dual feeds with clunks, balanced returns with jet, 1.5 N/S with 80 gram springs and stock jetting.

[Adam]

Machined head 36cc domes , 1.2mm squish , Advent 84 curve , carbs 120 mains 110 lows 95 gram springs 1.5 needle and seat , fuel pump equalisation mod done , filled Inlet manifold cross overs , Riva reed stuffers , Tau Ceti flame arrestors , 07 exhaust system. R&D plate , R&D 800 grate , stepped stock sponsons , R&D trim tabs , either a Skat trak setback 14 vane pump or a Yamaha High pressure pump with a 14/20yna fly impeller. Pump relief valves .