Results 1 to 2 of 2
-
06-17-2007, 10:31 AM #1
- Join Date
- May 2007
- Posts
- 4
2004 GTX 4 Tec Impeller Housing Replacement
Picked up some rocks and damaged the pump so I am in the process of replacing the impeller housing and impeller on our '04 GTX. Got everything apart except I can't seem to be able to get the last sleeve out of the housing (it is the bearing angle in the housing which the impeller shaft slips through).
It does not have many hours on it and everthing looks to be in good shape on these parts except those exposed to the rocks so I want to be carefull taking that part out. Any suggestions on how to get that one out?
Thanks in advance,
Coach Mike
-
06-18-2007, 08:25 AM #2
Mike are you sure you need a whole houseing. Usally I would just replace the wear ring. If not. I'll look at my shop manual tonight.And get back to you
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
2004 GTX 4-Tec SC, 160hr,Low oil / Sensor warning/Red flashing triangle
By Rodmac in forum 4-Tec PerformanceReplies: 8Last Post: 07-22-2013, 02:56 PM -
2004 Gtx 4-tec Oil Light and Limp mode and Beep, Already changed the 2 switches
By ShawnAzam in forum 4-Tec PerformanceReplies: 9Last Post: 04-29-2013, 05:43 PM -
2004 gtx 4 tec won't start
By Riverrat1494 in forum 4-Tec PerformanceReplies: 2Last Post: 04-09-2013, 10:48 PM -
Need Help!! 2004 GTX 4 tec SC Wont Start
By eddyk117 in forum 4-Tec PerformanceReplies: 0Last Post: 08-15-2011, 08:44 AM -
Pump assembly 2004 GTX 4-Tec Wake
By witness140 in forum 4-Tec PerformanceReplies: 7Last Post: 11-16-2010, 12:56 PM
Very clean install, what ECU will be running it?
Turbo Tuesdee!!!! 2.0