Page 2 of 2 FirstFirst 12
Results 11 to 14 of 14
  1. #11
    martincom's Avatar
    Join Date
    May 2010
    Location
    Brainerd, MN
    Posts
    1,401
    +1
    149
    The link is in post #3 of this thread.

  2. #12
    Hey guys,


    I´ve now managed to change the stator but needed to remove the engine twice because i had removed the gasket from the alternator housing and replaced it with silicon gasket. Through this mistake the starter was not running free...

    I´ve now put it back together, but it won´t start. I´ve measured the tension at the injectors and it never achieved 45V. I´ve allready checked and changed the cable colours like mentioned in the post about the miswired stators. I´ve checked the tension on every phase of the plug, it´s ok and even higher (9V/5,5V). But the resistance between 1 and 12 and 2 and 11 is about 0,8 Ohm. Is it possible that the new alternator is allready done?

    Has anybody an idea what to check before i burn down this moth*******

    best regards

    Hendrik


  3. #13
    martincom's Avatar
    Join Date
    May 2010
    Location
    Brainerd, MN
    Posts
    1,401
    +1
    149
    See post #3 of this thread for the link.

  4. #14
    Moderator HiPeRcO's Avatar
    Join Date
    Jul 2007
    Location
    Upstate NY
    Posts
    3,218
    +1
    275
    If the stator voltages are checking OK, then what voltage are you seeing on the white/red wire when cranking? (This can be more accessible if probed at the diagnostic plug rather than at the injectors). It should be 18-20VDC when cranking, and steady.

Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. MSX 140 running rough!!
    By Aarcurti in forum Polaris Open Discussion
    Replies: 15
    Last Post: 06-22-2020, 03:15 PM
  2. 2003 MSX 140. rough running issues. Temp related?
    By Britpilot in forum Polaris How To & FAQs
    Replies: 25
    Last Post: 01-21-2017, 04:14 PM
  3. 2000 Polaris virage FICHT rough idling and rough running
    By Durtdog44 in forum Polaris PWC Performance
    Replies: 9
    Last Post: 05-30-2016, 05:10 PM
  4. 2003 msx 140 runs rough while giving it the throttle.
    By dcspankie33 in forum MSX/Matrix
    Replies: 6
    Last Post: 09-02-2014, 09:29 AM
  5. MSX 140 Runs Rough at low-mid RPM range
    By Makon in forum MSX/Matrix
    Replies: 4
    Last Post: 08-04-2014, 08:27 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •