Results 1 to 10 of 28
Thread: measurments for block-offs
-
02-02-2006, 07:35 AM #1
measurments for block-offs
im stealing shibby's idea for getting measurments cuz im not sure who all has the pro-series blockoffs. I will like to know the measurments for the riva pro-series blockoffs. mainly the part that goes flush with the ski. i wanna see if i can make one but dont have measurments to go with. thanks!
-
02-02-2006, 07:56 AM #2
- Join Date
- May 2005
- Posts
- 349
Block offs
Rather make a ride plate extension works much better.
-
02-02-2006, 12:15 PM #3
so just keep the regular blockoffs and put an extension on the ride plate is better? thanks nickdog
-
02-02-2006, 01:54 PM #4
wasn't it found that the rideplate extension scrubs alot more top speed off?
-
02-02-2006, 02:29 PM #5
At 2" long it scrubbed considerable speed. At 1" im not sure if it scrubbed any on my setup. Im about to weld another extension back on my plate.
The handling and hookup thru chop is unreal with the extension. Just ask good2go!
-
02-02-2006, 05:05 PM #6
well i guess i will try the extension first and see what happens. i thikn its easier to make that then the blockoffs too!
-
02-02-2006, 07:19 PM #7
I would like to put a extension on my rideplate to jerry,but about how much mph would it take away at top end.
-
02-02-2006, 07:21 PM #8
You won't know until you try it
-
02-02-2006, 07:26 PM #9
I was also going to make my own pro blockoffs out of fiberglass but I came across some aluminum plate that would do the job.So what really would be better out of both?
-
02-02-2006, 07:31 PM #10
So if I go with a 2" extension I could always cut some off if its to much.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Seaching for Block off from the IMUK
By hkss in forum 4-Tec PerformanceReplies: 19Last Post: 03-27-2015, 04:39 AM -
WTT 2002 OPAS complete system for block off kit.
By Jasonsdad in forum 4-Tec PerformanceReplies: 0Last Post: 07-13-2011, 05:00 AM -
Sealant/Gasket for Block-Off plate?
By johnsonmtz in forum Polaris Open DiscussionReplies: 1Last Post: 07-23-2008, 03:17 PM -
jetting for block off kit?
By mbg75 in forum Polaris Open DiscussionReplies: 13Last Post: 08-10-2007, 07:25 PM -
Installing block off plate for stock I/C
By RXPNJ in forum 4-Tec PerformanceReplies: 3Last Post: 05-07-2006, 03:03 PM
Nevermind. I decided not to buy the ski.
Issue with Oil in Intake Air Box