Results 1 to 6 of 6
Thread: 12/1300 hull measure needed
-
06-12-2007, 05:34 PM #1
12/1300 hull measure needed
has any one got a gpr 12/1300 hull stripped out at hand...
from the inside rear of ski to the first and second engine mount holes/left and right hand side
found a hull for my now second in line project but think its a 800 hull but need you to confirm by telling me the hole distances for rear most inside ski..
if the holes in the hull on the 12/1300 are in pairs can you give to the best the middle of each pair left and right front and rear...
sorry to ask but if someone has a hull there it would save me a few days messing about....
thanks in advance paul
-
06-13-2007, 08:04 AM #2
Measurements
You may want to PM TCR Travis Church I know he has a couple of hulls and I think they are stripped out. He might take those measurements for you. He's always been very helpful to me.
-
06-13-2007, 01:05 PM #3
-
06-22-2007, 11:40 AM #4
not heard from TCR so can anyone help me..iv'e a gpr 800 hull that i want to fit the 1300 in and at the moment i cant find one person that has done it or any info on the job and how hard it is to do...
come on guys someone must know or i have to dump the hull as i aint got room if its a no go project....
-
06-22-2007, 12:03 PM #5
- Join Date
- Jul 2006
- Posts
- 1,269
- +1
- 2
I know someone has done it, I just cant remember who it was???? They even had a pic of their ski but I dont remember where in this forum I saw it.
-
06-22-2007, 12:03 PM #6
the rear mounts are in the right spots...
the front pair are too far back... so both of the front motor mount backing plates need to be moved forward and rivoted in place.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Does the the GP 800 have the same hull as the GPR 12-1300?
By SJ-(KY) in forum Yamaha Open DiscussionReplies: 3Last Post: 07-07-2009, 09:48 AM -
1300 cylinder information needed..please.
By HopatcongGPR in forum Yamaha PWC Performance (2-stroke)Replies: 0Last Post: 06-25-2006, 09:54 AM -
F/I vs. carb 1200 vs 1300 hull
By GP1500SC in forum Yamaha PWC Performance (2-stroke)Replies: 8Last Post: 04-10-2006, 05:40 PM -
97 GP 12 long post but need help bad!!!
By SLOW65U in forum Yamaha Old School SkisReplies: 26Last Post: 12-14-2005, 04:43 PM -
1300 hull crack...need advice please read
By RXPNJ in forum 4-Tec PerformanceReplies: 3Last Post: 06-28-2005, 10:30 PM
Take it to the dealer....
2007 wake 215... one loud beep 4...