Results 1 to 2 of 2
Thread: 2 to 3mph experimental intake
-
06-10-2007, 11:37 PM #1
2 to 3mph experimental intake
take a 4inch hose by 8 feet install it on the sc intake you should have the 4 inch adapter already installed, secondly remove the front glove compartent of your ski route the 8 feet hose through the glove compartment box hole and tie the hose on top or underneath your side mirror fronting the lake, as you gain speed impact air will enter the 4 inch hose that will bring up your rpm and speed. after this diy experiment you'll start brainstorming where to install your ram air intake infront of your ski. this is very tricky its up to you, you figure out your own design were to put holes and slots, so as not to have water injestion.
this experiment will make your day.
Goodluck
-
06-11-2007, 12:57 AM #2
don't worry bro, your concept is already being worked on
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
WTB 4" inlet adaptor to make 4 " intake
By Otto J in forum Sea Doo ClassifiedsReplies: 0Last Post: 07-26-2009, 07:21 PM -
Trying to decide on Intake setup for RXT
By RiseXagainst42 in forum 4-Tec PerformanceReplies: 1Last Post: 05-11-2009, 01:14 AM -
92 GTX overheating How to check coolant intake
By jeeprunnr in forum 2-Stroke PerformanceReplies: 1Last Post: 09-07-2008, 04:20 PM -
2-3mph experimental intake pics
By bert padua in forum 4-Tec PerformanceReplies: 1Last Post: 06-11-2007, 12:34 AM -
Anyone have extra tubing used to build air intake?
By MikeTrin in forum Sea Doo Open DiscussionReplies: 8Last Post: 05-03-2006, 11:46 PM
I have a 21 gp, and stage 2 tune. The speedometer will read above your...
2021 fx svho speedometer