Page 1 of 2 12 LastLast
Results 1 to 10 of 11

Thread: High rev FZR

  1. #1

    High rev FZR

    I知 running a fully built 2010 FZR with Riva Stage 3, R&D R4 flash. Pulls great on the low end but I知 on the 8800 rev limiter almost instantly, gps 81mph. My question is, I知 currently running 15/23 Skat Swirl, I壇 like to get more top end without riding the rev all the time. i know guys are running similar setups, curious what would you recommend. Does have the new 2013 clutch setup that was just replaced.


  2. #2
    Following this- sounds so bad ass

  3. #3
    Banned User
    Join Date
    Jul 2019
    Location
    Panama
    Posts
    13

    High rev FZR

    but those guys from sweden make it look so easy to get 1000 hp from these engines as long as you have the money and the know how. With money anything is possible.

  4. #4
    fx160's Avatar
    Join Date
    Nov 2005
    Location
    gold coast australia
    Posts
    2,509
    +1
    211
    Pitch up to 24 at least
    I知 assuming you still have 155mm pump setup
    You could also fit an svho pump setup
    Way better hookup and top end

  5. #5
    the stage 3 kit comes with the 160mm scat swirl 15/23 but like you said I would pitch it up one degree to start off

  6. #6
    fx160's Avatar
    Join Date
    Nov 2005
    Location
    gold coast australia
    Posts
    2,509
    +1
    211
    Mph seems low then for a 160 mm 15/23
    What ride plate are you running ?

  7. #7
    fx160's Avatar
    Join Date
    Nov 2005
    Location
    gold coast australia
    Posts
    2,509
    +1
    211
    14/24 scar 155 mm pump had me running 84 mph with a low boost wheel at 8,650
    2010 fzs

  8. #8
    I can tell you from experience and I wasnt the only one. What R&D said and did to my ecu were 2 totally different things. It was never the flash they said it was. Chasing problems for 2 seasons and turned out they never installed the rev limit they said it was and also turned out towards the end the boost limiter was always left on. Dean finally squared it away.
    So long story short your R4 may not even be an R4! May want to send it out to dean with your setup and have him do a flash. I know it sucks but at least what Dean installs is what Dean says it is!!!

  9. #9
    Quote Originally Posted by scittb View Post
    I can tell you from experience and I wasnt the only one. What R&D said and did to my ecu were 2 totally different things. It was never the flash they said it was. Chasing problems for 2 seasons and turned out they never installed the rev limit they said it was and also turned out towards the end the boost limiter was always left on. Dean finally squared it away.
    So long story short your R4 may not even be an R4! May want to send it out to dean with your setup and have him do a flash. I know it sucks but at least what Dean installs is what Dean says it is!!!
    I agree with u and what u say about R*D ecu work. I had one of their tunes on my 310 kaw and the ski had problems every since...im about ready to get a map tune for it.

  10. #10
    You are correct, 160mm scat swirl at 15/23

Page 1 of 2 12 LastLast

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. High rev at start up
    By hbernier in forum Polaris Open Discussion
    Replies: 6
    Last Post: 09-06-2017, 02:16 PM
  2. Rev's high out of water?
    By Wilson750 in forum Polaris Open Discussion
    Replies: 5
    Last Post: 08-27-2016, 08:54 PM
  3. High Rev, no thrust problem
    By jbryzek in forum Sea Doo Spark
    Replies: 10
    Last Post: 06-08-2015, 09:08 PM
  4. Stock RXT with high rev
    By nsschwenk in forum 4-Tec Performance
    Replies: 2
    Last Post: 08-21-2012, 02:12 PM
  5. Need so HELP! High Rev
    By jared4brack in forum Polaris How To & FAQs
    Replies: 19
    Last Post: 08-06-2009, 11:51 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •