Hi, all.

I'm a newcomer to GreenHulk. Thank you in advance for your help!

My 1996 Wave Venture 1100 blew a head gasket earlier this summer. When I replaced the gasket, I noticed that the tops of the sleeves were a little below tops of the cylindersóless than a millimeter but definitely below. Have my sleeves slipped?

After replacing the head gasket, it ran fine for a few hours. Last week, it lost compression on cylinder 2 again. I expect the gasket is gone. I'll probably pull the head tomorrow to confirm.

My guess is that I need to pull the cylinders and level the sleeves with the tops of the cylinders.

If anyone can provide some insight, I would really appreciate it!

Thank you.