Results 1 to 3 of 3
Thread: mikuni carb reinstallation HELP
-
07-24-2019, 02:50 AM #1
- Join Date
- Jul 2019
- Location
- utah
- Posts
- 24
mikuni carb reinstallation HELP
So i’ve rebuilt my mikuni sbn 38 triple carbs and i’m getting ready to see if my 1994 SLT will start runnin again. just wondering how to prime the carbs and what to do once i’ve got them reinstalled.
-
07-24-2019, 08:45 AM #2
I found the fastest way to prime everythign is to mix up some gas and oil, and dripple a little down each carb, the engine running will create faster pulse lines, and help get fuel into the engine faster, DO NOT USE STARTER FLUID as it will not have the oil to lubricate your engine. it should only take 1 or 2 starts to get the system primed
Did you replace all the fuel lines and upgrade to the triple outlet fuel pump as well?
-
07-24-2019, 01:05 PM #3
- Join Date
- Jul 2019
- Location
- utah
- Posts
- 24
thank you much, i was about to use starter fluid but the previous owner already replaced the fuel pump and fuel lines look good.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
87' JS550 Mikuni Carb
By jluca in forum Kawasaki PWC Performance (2-stroke)Replies: 1Last Post: 06-18-2013, 09:17 AM -
Mikuni Carb Cleaning
By skigolfnut in forum Kawasaki Open DiscussionReplies: 1Last Post: 12-30-2010, 11:36 AM -
Mikuni carb clean
By skigolfnut in forum Polaris Open DiscussionReplies: 2Last Post: 12-28-2010, 08:44 AM -
Carb reinstallation problem. . . . .
By oct6454 in forum 2-Stroke PerformanceReplies: 13Last Post: 06-22-2009, 07:37 PM -
Need help identifying Mikuni carb
By cigarlust in forum Kawasaki PWC Performance (2-stroke)Replies: 2Last Post: 06-07-2009, 06:43 PM
2002 was first year for 4 tech. There were no supercharged engines that...
155hp or 185hp Short Block How to...