Results 1 to 8 of 8
Thread: Impeller shaft replacement
-
05-01-2019, 01:56 PM #1
Impeller shaft replacement
I am pulling my pump for maintenance. The ski has about 190 hours on it. I am going to replace the seals and bearings. Is replacement of the of the impeller shaft necessary if it isn't damaged? Everything turns fine and it doesn't make any noise.
-
05-01-2019, 02:01 PM #2
-
05-01-2019, 02:03 PM #3
-
+1 by:
-
05-01-2019, 09:00 PM #4
-
05-02-2019, 03:27 AM #5
-
05-02-2019, 03:28 AM #6
-
05-02-2019, 06:39 AM #7
-
05-02-2019, 08:50 AM #8
Thanks everyone. The manual says to run your fingernail on the shaft where the seal lip is and if it isn't perfectly smooth, replace it. I was just trying to get ahead on my parts order and didn't want to buy a $95 part if I didn't have to. Pulling the pump this weekend to inspect it.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Stripped impeller and shaft, shaft rubbing on carbon ring.
By TAC in forum 4-Tec PerformanceReplies: 2Last Post: 06-06-2013, 10:58 PM -
SC shaft replacement opinion??
By SpeedJunky in forum Yamaha PWC Performance (4-stroke)Replies: 15Last Post: 03-01-2012, 01:07 PM -
WTB Coupler Shaft, Drive Shaft, & after market Impeller for XLT1200
By spham in forum Yamaha ClassifiedsReplies: 2Last Post: 08-19-2010, 01:46 PM -
1995 SL750 Impeller shaft bearing housing replacement
By skigolfnut in forum Polaris Open DiscussionReplies: 1Last Post: 07-06-2009, 09:47 AM -
08 Tx Impeller Shaft Replacement
By STSPERFORMANCE in forum Sea Doo Open DiscussionReplies: 5Last Post: 09-14-2008, 11:04 PM
30* ?? What fuel you running E85 or MS109?
FZR-R3 Turbo build