Page 1 of 2 12 LastLast
Results 1 to 10 of 12
  1. #1

    RXP Tuning Problems High Idle 06 RXP

    Hi Guys, I started this project a few years ago, got frustrated and bought an 300 RXPX. Now it's time to get back to it. It's an 06 RXP 215, I put Riva xx supercharger wheel,stainless exhaust valves, heavy duty springs, rear exhaust, 4"Kanaflex intake, ECU flash, OPAS block off, 50 lb injectors, AFR guage, Intercooler, stainless wear ring, max loader grate, rising rate fuel pressure regulator. The problem is now it idles at 2500 plus. Any suggestions? Someone told me the throttle body needs to be reset, but I can't seem to find anyone in my area Massachusetts that works on performance tuning. Thanks your help would be greatly appreciated


  2. #2
    raiderx72's Avatar
    Join Date
    Jul 2007
    Location
    Rocky Hill, CT
    Posts
    735
    +1
    75
    Any dealer should be able to reset it. Also you could check the cable and make sure it's not out of adjustment too.

  3. #3
    Hi, I did check the cable and backed off the adjustment with no change. My local dealer pretty much told me with all the mods I did they don't want anything to do with it.

  4. #4
    ptscon's Avatar
    Join Date
    Jul 2013
    Location
    Toronto
    Posts
    3,731
    +1
    778
    Those have mechanical throttle body, there's no resetting.

    If the linkage is all good than high idle will usually mean a vacuum leak somewhere around the intake manifold.

  5. #5
    raiderx72's Avatar
    Join Date
    Jul 2007
    Location
    Rocky Hill, CT
    Posts
    735
    +1
    75
    There is a throttle position sensor that can be reset

  6. +1 by:


  7. #6
    I guess a good place to start would be to replace the intake gaskets, or can I run it and spray carb cleaner on the intake to look for a leak that way?

  8. #7
    Chrisx88's Avatar
    Join Date
    Oct 2018
    Location
    Rochester NY
    Posts
    152
    +1
    5
    Take it to dealer and have the TPS reset. Then go from there.

  9. #8
    This is how I run a jetski shop in the desert nmpeter's Avatar
    Join Date
    May 2008
    Location
    Elephant Butte New Mexico
    Posts
    8,343
    +1
    1,966
    you might want to look into the idle air controller, after all it's 13 years old.

    before you go back to the dealer. or just invest in a home candoo.

  10. #9
    Any Massachusetts area shops that I could bring this to?

  11. #10
    This is how I run a jetski shop in the desert nmpeter's Avatar
    Join Date
    May 2008
    Location
    Elephant Butte New Mexico
    Posts
    8,343
    +1
    1,966
    Sure any shop will be able to replace your idle air controller and charge you an hour to do it

Page 1 of 2 12 LastLast

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Idle rpm is to high, RXP 255
    By Andyk in forum 4-Tec Performance
    Replies: 0
    Last Post: 07-16-2016, 10:27 AM
  2. 2008 RXP-X High Idle
    By Center87 in forum 4-Tec Performance
    Replies: 7
    Last Post: 03-27-2016, 11:03 AM
  3. 2014 RXP-X high idle
    By RossM in forum 4-Tec Performance
    Replies: 15
    Last Post: 09-05-2014, 03:32 PM
  4. RXP, High Idle, Low RPMS? --Help me out!
    By RX-Pike in forum 4-Tec Performance
    Replies: 33
    Last Post: 07-25-2009, 10:42 PM
  5. HIgh Idle on 07' RXP???
    By NJRXP in forum 4-Tec Performance
    Replies: 6
    Last Post: 05-18-2007, 12:10 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •