Results 1 to 7 of 7
  1. #1

    Thumbs up 2005 Pump Install


    I've been trying to get ahold of you for a few days, I just have a couple questions before I send my stuff out. Give me a call when you can. Thanks!

  2. #2
    Nate I got your message but your phone number I was not able to decifer . I will be in town and the address that you recited was correct. try calling me again.



  3. #3
    Will do, thanks!

  4. #4
    I got everything on Friday and installed it. I picked up about .6 MPH so far but that was right off the bat. I haven't been able to fully test it out but it's looking good. My RPMs are right at 7030-7040. Speed was 70.1 with the stock plate.

  5. #5
    Update, better weather and I didn't have my girlfriend with me this time. Went 74 MPH basically (73.9) at 7120 RPMs. I did drill holes in the bucket/windscreen prior to this run and I also switched back to my FF plate from Jim.

  6. #6
    Your number has not come accross my phone. Call me tomorrow.


  7. #7
    Haha I know, you're a busy guy. Figured I'd hit you up here on the board I'll call you tomorrow then.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. RXP Bilge Pump install
    By Vern in forum 4-Tec Performance
    Replies: 14
    Last Post: 08-27-2014, 10:04 AM
    By RX951 in forum Yamaha How To & FAQs
    Replies: 25
    Last Post: 05-01-2007, 09:10 PM
  3. Putting 2005 pump on my 2002 xlt1200
    By Chezzy in forum Yamaha PWC Performance (2-stroke)
    Replies: 12
    Last Post: 07-07-2006, 07:45 AM
  4. 2005 pump swap for 2001-2002 GPR
    By TJBrad04 in forum Yamaha PWC Performance (2-stroke)
    Replies: 5
    Last Post: 03-14-2006, 05:41 PM
  5. Pump install question.
    By Mark S in forum 4-Tec Performance
    Replies: 2
    Last Post: 07-01-2005, 09:25 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts