Pet tach 21000dxr need help

[2017 fx svho]

Was up gh community i just recieved my pettach 21000dxr and it came with no instructions 😑 how do you install on a svho motor and how do you set it to read rpms

[BLASTER 1]

Just cut the clip off the wire and wrap it a few times around the coil then in a X pattern and run the wire to where your going to mount the tach. Use 4:1 for reading your rpm. 4=4 stroke 1= single cylinder
Also use a zip tie to keep the wire on the coil

[Mr. GP1800]

You can also install a different wire if you need a longer one.

[Mr. GP1800]

Just cut the clip off the wire and wrap it a few times around the coil then in a X pattern and run the wire to where your going to mount the tach. Use 4:1 for reading your rpm. 4=4 stroke 1= single cylinder
Also use a zip tie to keep the wire on the coil

How did you do your bars? That looks like a stock bar with a umi pad

[BLASTER 1]

How did you do your bars? That looks like a stock bar with a umi pad

It is, stock bars with 1 inch aluminum extensions on each side and then 140mm odi grips much better then stock

[Outboardjohn]

Sorry for taking this thread a bit sideways, but I just wanted to let you guys know that if you search on Amazon for "clamp on handle bar grips" you can find generic grips that seem identical to ODI for MUCH less $! I got 2 pair for $8.99!!

[2017 fx svho]

Thanks for the help brotha going to install first thing in the morning and is it very accurate?

[BLASTER 1]

Thanks for the help brotha going to install first thing in the morning and is it very accurate?

It it is very accurate, maybe someone here at greenhulk can get you the instructions or maybe google it because the tach does a few things that can be helpful to you

[Mr. GP1800]

I’m pretty sure I have the instruction sheet laying around here somewhere. And yes this tach is dead on accurate. It’s the best one out there