Results 1 to 4 of 4
Thread: RIVA Valvetrain Install
-
05-30-2007, 08:55 PM #1
RIVA Valvetrain Install
Thanks to brendon for loaning me the compression tool which i will be sending out tomorrow
, i was able to do the upgrade in 2 hrs....very easy to do i am not sure how anyone could screw it up. the only tricky part was getting the keepers back in place....i am ready for the high RMPS now....
air was leaking out of the hose that connects to the valve cover but i figured that was no big deal....air compressor kept up just fine...i ran about 85psi in each cylinder and when i switch from cyl to cyl the motor turned over, normal i assume.
can't wait to get my ECU and IC....
-
05-30-2007, 09:24 PM #2
I am jealous I have the kit but I am to chicken to install it before the bug I might screw something up and not have a ski to ride for the bug
-
05-30-2007, 10:36 PM #3
-
05-31-2007, 07:28 AM #4
the magnet on the stick is deff required so you do not drop the keepers, i used marine grease on them to keep them in place when putting them back in, i used angled vise grips to put them in place then rotated them with my fingers in place...
the only tricky part was getting them to unseat so i could take the keepers out....sometimes the valve would just go down and air would come out the exhaust.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Riva Valvetrain install.
By Water4fire in forum 4-Tec PerformanceReplies: 30Last Post: 12-11-2008, 05:07 PM -
Riva IC install in a GTX SC...
By Pale Rider in forum 4-Tec PerformanceReplies: 38Last Post: 09-08-2007, 08:12 PM -
Riva Head Installation question
By howestek in forum Yamaha PWC Performance (2-stroke)Replies: 28Last Post: 03-04-2007, 08:51 AM -
RIVA valvetrain upgrade installation with RIVA tool
By Green Hulk in forum 4-Tec PerformanceReplies: 31Last Post: 10-15-2006, 07:57 AM -
idling rough after riva intake install
By Insanediego Joe in forum 4-Tec PerformanceReplies: 62Last Post: 07-11-2006, 09:49 PM
I noticed it was smoking a lot at idle so I pulled the exhaust off to look...
Gp1300 oil pump stuck at full