K447 Garage sale

[K447]

I think there was maybe ten hours on the engine from new when this throttle body assembly was removed. That engine was converted to carburetors with triple tuned exhaust pipes.

This has been kept in clean dry storage since then.

$75 including shipping.

[K447]

I am not sure which model/year this came from

Includes three circlips, which I also forget why they are with it

Good working condition, but not quite pristine.

$55 including shipping within continental USA.

[K447]

Only one of the base plates has the Ficht air temperature sensor installed. I think the sensor is good but have not tested it. There is a rub mark where the plastic cover fits.

Asking $10 plus shipping. If you buy something else, shipping could be combined.

[K447]

None of these are for models with nozzle trim. These are just pump nozzles with steering nozzle.

Not sure which models they originally came from, one MIGHT be from a Hurricane (extended steering nozzle?)

Update: All three of these nozzle assemblies appear to be the same.
~86mm steering nozzle diameter
~92mm steering nozzle length
Jet pump exit nozzle sections also all appear to be the same.

Since I only parted out one Hurricane and maybe had a nozzle from one other, it appears that all three I have here are ‘standard’ nozzles 🤷

Three to choose from, asking $40 plus shipping, obo.

[K447]

5131273 Inlet Scoop
Removed from 1997 Hurricane, I think it should also fit many other models?

Fits to hull in front of jet pump base in jet pump tunnel. Intake grate fits into groove in front edge of this part.

Part number 2 in this diagram

[K447]

Extracted from a 2002 Freedom, this round fuel gauge and associated LR module would work in any year Freedom.

It should also work with any other Polaris PWC model or any boat marine fuel tank with a standard 33 ohm to 240 ohm level sender.

The LR-85 module provides the regulated voltage to power the gauge.

I have not powered it up since I bought it a few years ago. As far as I know it should be in good working order.

Wire connections can be extracted from the wiring diagram for the Freedom. Fairly straightforward.

[K447]

There is a smudge inside the LCD but otherwise this round MFD works just fine. Small scratch on the screen, not a crack.

I have cut it open and the case has not been resealed yet. I normally use black epoxy (or JB Weld epoxy) to reseal an MFD case. Not hard to do.

The engine hour counter has been reset to zero and the voltage display was calibrated.

Note: The round MFD is direct plug compatible with the 8-pin oval MFD, both can work interchangeably.

Comes as shown in photos.

[K447]

Found a Polaris security module hiding in my house.
Make me an offer.

It is adaptable to ‘any’ Polaris 2-stroke and quite possibly a lot of other machines.

http://greenhulk.net/forums/showthre...=1#post2424055

http://greenhulk.net/forums/showthre...=1#post1400912

[K447]

If there is ANYTHING in this list that is of ANY interest to you, please let me know.

It is 2021 and I do not want this stuff sitting around come springtime. If it is still listed below then I probably still have it, for now.

Make me an offer.

Shipping will be from Ontario, Canada as the US-Canada border is currently closed to casual crossings.

If you are serious I will pack and weigh the box of stuff for you, then you pay for the shipping cost plus whatever amount we agree for the items(s).

At some point whatever remains from this list will be going away forever.