Results 1 to 5 of 5
Thread: Anyone make thier own resonator?
-
02-16-2017, 08:41 PM #1
Anyone make thier own resonator?
I have a 08 Speedster 150. The exhaust hose for the resonator popped off. It was my mistake since I used 1 clamp instead of two and not tight enough. Luckily it was just a test and the trailer was right there. I switched to a t-bolt clamp but it seems that when I crank it down (probably too tight) it makes the hose slip off. I then made it snug and pulled on it seems okay. BUT I am still nervous about it popping off. I compared these old resonators to my newer one (2012 GTR) and the exhaust hose is like 2.75 and the resonator is 2.55 so the hose isn't snug unless the clamp is on. The GTR resonator is like 2.75 and has a nice huge lip. The hose is snug without a clamp and its a 90 degree bend instead of straight. I tried fitting the GTR resonator but it won't work with the 3" IC pipes.
Has anyone made their own out of PVC? I don't want it louder (resonator delete) and hate to do the thru-hull but that might be my only choice. A 3" hole with water coming in happens really fast!!
-
02-16-2017, 08:59 PM #2
I have a resonator that I'm sure would work if you would rather just replace it
-
02-16-2017, 09:02 PM #3
- Join Date
- May 2010
- Location
- Jax,FL
- Posts
- 4,228
- +1
- 857
You I have a stock low hour one from px260 I'd probably let go...
-
02-17-2017, 01:24 AM #4
-
02-17-2017, 08:39 AM #5
Post a pic of the stock resonator in the boat if you can might help the brainstorming process haha
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Anyone make their own "pump seal kit"
By Bamaha1 in forum Yamaha PWC Performance (4-stroke)Replies: 8Last Post: 07-18-2013, 10:33 AM -
Anyone make their own sponsors?
By thetolleyman in forum Open DiscussionReplies: 4Last Post: 08-11-2012, 09:03 PM -
Anyone make their own BOV piping?
By SlowStang305 in forum Yamaha PWC Performance (4-stroke)Replies: 2Last Post: 12-08-2010, 11:36 PM -
anyone make their own intake for the SHO?
By allstar71 in forum Yamaha PWC Performance (4-stroke)Replies: 2Last Post: 08-02-2008, 05:03 AM -
Does anyone make a header?
By flyn ryan in forum 4-Tec PerformanceReplies: 25Last Post: 05-17-2006, 04:05 AM
Temp sensor on bottom of stinger pipe?
Gp1300r won’t start/only backfire