Page 4 of 4 FirstFirst ... 234
Results 31 to 32 of 32
  1. #31

    Join Date
    Feb 2014
    Location
    Northern California
    Posts
    59
    Quote Originally Posted by K447 View Post
    I generally loosen the two through-hull hose clamps (or not tighten them yet) before installing the driveshaft. After driveshaft is in place I will twist and wiggle the through-hull assembly and the rubber sleeve to allow it to settle into place (hopefully in a low stress alignment with the driveshaft), then snug the hose clamps.

    The seals cannot wear unevenly until the bushings have worn unevenly. I agree that there should not be large sideways or canted forces acting on the through-hull bushings once everything is installed. That will maximize service life of the bushings and the seals.
    I have purchased a couple of these kits from SBT, will these work on my 02 Genesis Skis?


  2. #32
    Moderator HiPeRcO's Avatar
    Join Date
    Jul 2007
    Location
    Upstate NY
    Posts
    3,015
    +1
    242
    Which "SBT kits" are you referring to?

Page 4 of 4 FirstFirst ... 234

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Replies: 6
    Last Post: 06-18-2015, 09:39 PM
  2. Replies: 6
    Last Post: 12-16-2013, 04:17 AM
  3. Replies: 0
    Last Post: 12-10-2013, 01:20 PM
  4. Drive shaft through-hull bearings; greasing frequency and grease quantity
    By ben01251979 in forum Polaris Open Discussion
    Replies: 4
    Last Post: 06-22-2013, 10:42 PM
  5. WTB Through Hull Bearing and Bilge Pump for 2002 Virage Ski
    By dalepatter in forum Polaris Classifieds
    Replies: 1
    Last Post: 09-05-2011, 10:12 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •