Results 1 to 4 of 4
  1. #1

    2005 gp800r powerbalves

    My power valves do not cycle when the ski is turned off. I also cannot get to full power in the water. I'm assuming that this is because the power valves are not cycling but I'm not sure. Could use any help you guys have. Is there a way to test the servo motor? Anything I could try will help. Thanks

  2. #2
    jeffg426690's Avatar
    Join Date
    Jul 2015
    Location
    Sarasota, FL
    Posts
    594
    +1
    55
    wire tap into the grey wire and put it to ground momentarily w plug still connected and the servo should cycle. Just for a second, don't hold it on ground longer than a second one or two.

  3. #3
    I would take the cables off and see if you can manually run them from one extreme to the other and see if they might be binding. If they are free then I would check the cables.

  4. #4
    all fixed it was a bad connector thanks guys


Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. FS 2005 GP800R & Trailer MI (lower $)
    By GP12Russ in forum Yamaha 2 Stroke Skis
    Replies: 5
    Last Post: 10-04-2015, 11:31 PM
  2. 2005 GP800r Question. 2
    By jrush in forum Yamaha How To & FAQs
    Replies: 1
    Last Post: 04-02-2015, 02:06 PM
  3. question on a 2005 yamaha GP800r caveating at 4000 rpm
    By TheHive in forum Yamaha Open Discussion
    Replies: 5
    Last Post: 05-27-2013, 05:57 AM
  4. 2005 GP800r taking on water!!!
    By Mjmattia in forum Yamaha PWC Performance (2-stroke)
    Replies: 6
    Last Post: 08-29-2012, 04:22 PM
  5. FS yamaha 2005 gp800r
    By bksbigboy69 in forum Yamaha Classifieds
    Replies: 0
    Last Post: 11-09-2010, 07:17 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •