kit to fix the timing chain issue

[JIM'S PERFORMANCE]

here is a kit riva put togeather for my customer to fix the timing chain issue that i am installing. New crank, new guides both, new gears, new chain. It's available here in the forums online store
http://www.4-tecperformance.com/inde...oducts_id=4050

Here are some pics.

[Ski Hacks MG]

I am assuming these are 2016 parts to retrofit into the 14/15 skis. Whats the cost?

On a side note, it's a damn shame to have to go to this extent to fix a known mechanical issue.

[JIM'S PERFORMANCE]

I am assuming these are 2016 parts to retrofit into the 14/15 skis. Whats the cost?

On a side note, it's a damn shame to have to go to this extent to fix a known mechanical issue.

Yes they are 2016
Did not ask him what the total cost was.

[zapufast]

I am assuming these are 2016 parts to retrofit into the 14/15 skis. Whats the cost?

On a side note, it's a damn shame to have to go to this extent to fix a known mechanical issue.

Yes they are 2016
Did not ask him what the total cost was.

That was my next question...

[Ale]

oem parts cost + work ...

it's better trade in 2014/15 for newer 2016 model.

[Mike H]

The cost, 1498.00 is in the performance parts store. Its a kit jerry sells now.
http://www.4-tecperformance.com/inde...oducts_id=4050


In the yamaha section in the internal upgrades part

Total cost if you did the work yourself is probably little under 2k after gaskets/bearings and stuff

[Ski Hacks MG]

Jim, you have a golden opportunity to do a nice video on the process. Just think, you could be a YouTube sensation. Hint Hint.

[JIM'S PERFORMANCE]

Jim, you have a golden opportunity to do a nice video on the process. Just think, you could be a YouTube sensation. Hint Hint.

from start to finish will be way to long of a video. Might do sections on changing every piece.

[incognito]

Jim,Are bearing journals (mains & con rods) the same size as the 14/15's?,and when or if. U do a refit do u use plasti-gauge for correct bearings? And is crank marked for. Each journal bearing size by a color code? P.S.is cam gear on crank pressed on, or machined as part of crank?thx

[wheresmike]

Is there any evidence to support the 2016 not havering the same problem?