Results 1 to 6 of 6
  1. #1

    CDCV 2000 zxi 1100 pilot screw location

    got these carbs all tore apart and cant find the pilot screw or any diagrams on the break down. the service manual varies and has a update on the information but no pictures to go with it. Any help would be great thanks !!!
    Last edited by 2000ws6transam; 08-12-2015 at 02:58 PM.


  2. #2
    DavidR's Avatar
    Join Date
    Jul 2013
    Location
    Forney,Tx
    Posts
    799
    +1
    45
    I think they have a plug over them from the factory.

  3. #3
    steve45's Avatar
    Join Date
    Feb 2008
    Location
    Texas
    Posts
    5,993
    +1
    431
    Mine were covered in grease. You have to take the carbs off to find them.

  4. #4
    The majority of those carbs were set and plugged off with blanking caps in the factory. The screws are set at 1-3/4 turns out. Don't play with them mate. Take it from someone who has already been there. I had to remove the caps from mine by using a 1/8th drill bit and a seal pick. The reason why I had to remove them was because I fitted larger pilot jets because someone else had removed the chokes and fitted a primer kit which makes the engine run lean in the lower part of the Rev range.

  5. #5
    humm if thats the case i better not, i might just get larger main jets then. i took it out on the lake after putting th4e carbs back together and it wouldnt even go 10 mph.. so i think something is bad or gaskets i did adjust the float arms a little bit to the factory settings. ill just rebuild them and try again lol

  6. #6
    steve45's Avatar
    Join Date
    Feb 2008
    Location
    Texas
    Posts
    5,993
    +1
    431
    What was wrong with it to start with?

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. 2 questions re: 2000 ZXi 1100
    By CHH777 in forum Kawasaki Open Discussion
    Replies: 3
    Last Post: 06-29-2011, 02:25 PM
  2. 2000 ZXI 1100 Mod Priority List
    By brax in forum Kawasaki PWC Performance (2-stroke)
    Replies: 34
    Last Post: 07-09-2010, 01:56 PM
  3. WTB I need a crank shaft for a 2000 zxi 1100
    By koryk in forum Kawasaki Classifieds
    Replies: 0
    Last Post: 04-27-2010, 08:31 AM
  4. Will the pump from a 2000 zxi 1100 work on a 99 900stx?
    By Piranha Performance in forum Kawasaki Open Discussion
    Replies: 1
    Last Post: 08-05-2009, 09:37 AM
  5. FS 2000 zxi 1100 ($2000) not mine albany,ny
    By stingray152003 in forum Kawasaki Classifieds
    Replies: 0
    Last Post: 05-15-2008, 12:04 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •