Really want a grate that doesn't "Pull to the right". Suggestions?

[Ski Hacks MG]

2010 RXTX 260

I've looked hard at WORX but it appears that it scrubs speed in exchange for straight tracking. What grate is going to track straight and [at least] keep my speed where it is (or gain a little)?

[1tommygunner1927]

Riva Stainless Steel......

[Scott]

Riva Stainless Steel......

Thing could also be used as a weapon!

[Ski Hacks MG]

So this one?

http://www.4-tecperformance.com/inde...oducts_id=2298

[1tommygunner1927]

So this one?

http://www.4-tecperformance.com/inde...oducts_id=2298

Yes. JPT7779 did back to back tests on various grates for the 2010 TX awhile back.
http://www.greenhulk.net/forums/showthread.php?t=173742

BTW, I'm waiting for the Riva SS grate to arrive.

[Ski Hacks MG]

So this one?

http://www.4-tecperformance.com/inde...oducts_id=2298

Yes. JPT7779 did back to back tests on various grates for the 2010 TX awhile back.
http://www.greenhulk.net/forums/showthread.php?t=173742

BTW, I'm waiting for the Riva SS grate to arrive.

I had seen that thread but thought he only tested R&D versus Worx.

[Scott]

So this one?

http://www.4-tecperformance.com/inde...oducts_id=2298

Yes. JPT7779 did back to back tests on various grates for the 2010 TX awhile back.
http://www.greenhulk.net/forums/showthread.php?t=173742

BTW, I'm waiting for the Riva SS grate to arrive.

I had seen that thread but thought he only tested R&D versus Worx.

Glade rider did testing as well.

I personally run the Riva grate since its stainless. I'm not looking for trouble using cast

[jpt7779]

I tested the Riva SS gate near the end of that thread and I highly recommend it!

Replace your stock bolts with grade 8 bolts, especially if you have been swapping out grates frequently. Evans failed the other day and he got banged up!

[07BRPRXP]

So you guys think the riva is better than the r&d??? I purchased the r&d but if the riva is better I'll switch! R&d is still in packaging... Thx

[greenbullet]

Riva or R&D

if if you don't have good alignment of the grate underneith sure it will pull to the right
sometimes you need to mod the holes a little for proper fitment