Results 1 to 4 of 4
Thread: VTS Motor Leak!
-
08-05-2015, 11:57 AM #1
VTS Motor Leak!
I had a bad trim motor so I replaced it with a new one. Took it out in the water and it started to let a lot of water into the engine compartment. It was flowing in behind the VTS motor, when I replaced it I did not see a seal that could prevent this.
Any help?
-
08-05-2015, 12:50 PM #2
Not sure about your year doo, but my 98 had bellows over the shaft that moves the nozzle up and down. The bellow are rubber and get old and crack letting water into your VTS housing. It took out my motor.
-
+1 by:
-
08-05-2015, 02:10 PM #3
What Johnny said ... replace the boot, they wear out and crack. Pack it full of grease too, helps seal out and keep shaft moving without binding, then clamp it correctly.
-
08-06-2015, 05:30 PM #4
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
RXP-X - Water in VTS motor normal???
By Mikey G. in forum 4-Tec PerformanceReplies: 5Last Post: 07-20-2008, 11:09 PM -
05 VTS motor
By ARNYGOLLOTT3 in forum Sea Doo ClassifiedsReplies: 10Last Post: 07-10-2008, 08:57 AM -
WTB: VTS motor for 98GSXL
By DPG98GSXL in forum Sea Doo ClassifiedsReplies: 0Last Post: 07-09-2008, 10:00 PM -
VTS Motor question...
By 1996XP in forum 2-Stroke PerformanceReplies: 5Last Post: 06-08-2008, 08:17 PM -
Will this work for a vts motor?
By skirtchaser in forum 2-Stroke PerformanceReplies: 8Last Post: 05-06-2008, 06:17 PM
baffled here as well where to mount it other than the little hole on the...
NEW RIVA Yamaha 2012 & Newer 1.8L...