Results 1 to 7 of 7
-
07-31-2015, 07:55 AM #1
R & D Exhaust Manifold X-Tender / O2 Sensor Mount Kit
Any one have one of these? Needing one ......
-
07-31-2015, 08:16 PM #2
- Join Date
- Feb 2008
- Location
- Los Angeles Area
- Posts
- 486
- +1
- 27
you'll get a lot of people tell you not to get one because it doesn't work.
-
07-31-2015, 10:35 PM #3
You wouldn't want to just tap your! Unless you have a pre 08 one.
-
08-03-2015, 06:31 AM #4
This thing works great, I highly recommend it! Way easier than tapping your ex manifold, however depending on what waterbox setup you are running it may or may not work for you. Was designed for people running their exhaust out of the stock location. If you are running straight out the back chances are it won't fit.
-
08-03-2015, 09:05 AM #5
SORRY IT DOES NOT FIT CORRECTLY, without modification!!
Period. In order for it to work correctly you need to cut you exhaust bell off or drill through it in the area the O2 sensor is above. as the Extension puts the O2 sensor wright above the bell and 100 percent you don't get correct reading until you cut it off or drill a big hole in the O2 sensor area.
-
08-03-2015, 12:27 PM #6
I've heard that before so had it set up both ways to see for sure and I found the readings on my machine were exactly the same, even changed the o2 sensor to make sure and they were the same and they were, it just needs to sniff the air. The plugs and egt's confirmed my findings as well.......
To each their own.......
-
08-17-2015, 07:28 PM #7
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
R&D Exhaust Manifold X-Tender / O2 Sensor Mount Kit
By jetmanjay in forum 4-Tec PerformanceReplies: 7Last Post: 09-07-2010, 01:28 PM -
FS R&D Exhaust Manifold X-Tender / O2 Sensor Mount Kit
By Luis Marine in forum Sea Doo ClassifiedsReplies: 0Last Post: 06-21-2010, 10:32 PM -
WTB R&D Exhaust Manifold X-Tender / O2 Sensor Mount Kit
By pedruko in forum Sea Doo ClassifiedsReplies: 4Last Post: 03-30-2010, 05:57 AM -
R&D Exhaust Manifold X-Tender / O2 Sensor Mount Kit
By pedruko in forum 4-Tec PerformanceReplies: 6Last Post: 03-21-2010, 09:38 PM -
WTB R&D Exhaust Manifold X-Tender / O2 Sensor Mount Kit
By stevorxp007 in forum Sea Doo ClassifiedsReplies: 2Last Post: 11-23-2009, 06:37 PM
Are you using zip ties for your line clamps?? If so, replace with Oetiker...
When I open the power valve the...