Results 1 to 1 of 1
-
07-28-2015, 07:00 PM #1
- Join Date
- Jul 2014
- Location
- Lake of the Ozarks/ Houston, TX
- Posts
- 36
- +1
- 1
Drive shaft and impeller corrosion?
I have owned and ridden seadoos for years, but never in salt water. I may be pursuing a job near the ocean and was curious how bad the drive shaft and impeller corrode. I have looked into leaving my seadoo on a lift in a marina, so it may be difficult to thoroughly rinse/clean them off. The reason for this is I won't have anywhere else to keep it.
I have also read the driveshaft is rubber/plastic coated, if so, how well does it hold up?
I have a 2010 rxp-x
Thanks,
Jordan
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Sheared drive shaft and impeller
By skysurfer2010 in forum 4-Tec PerformanceReplies: 4Last Post: 08-21-2014, 02:19 PM -
WTB Rxpx drive shaft and impeller
By monaroman76 in forum Sea Doo ClassifiedsReplies: 9Last Post: 01-05-2012, 01:53 AM -
Stripped Drive Shaft and Impeller
By Overcenter76 in forum 4-Tec PerformanceReplies: 10Last Post: 11-01-2009, 12:54 PM -
WTB '99 GP800 Drive shaft AND Impeller ASAP!
By ProXR 440 in forum Yamaha ClassifiedsReplies: 4Last Post: 07-16-2008, 05:47 PM -
Will Virage drive shafts and impellers work on 750 hull from 94?
By JGringo in forum Polaris Open DiscussionReplies: 14Last Post: 08-18-2007, 12:47 AM
baffled here as well where to mount it other than the little hole on the...
NEW RIVA Yamaha 2012 & Newer 1.8L...