Page 1 of 2 12 LastLast
Results 1 to 10 of 16
  1. #1
    rcab85's Avatar
    Join Date
    Nov 2011
    Location
    lavalette, New Jersey, United States
    Posts
    1,612
    +1
    84

    safest recreation setup?

    couple of questions here gurus
    question #1 what are the best sponsons for 09-13 fzr?
    #2 best boost wheel no rrfpr? have c1 now need more.
    #3 how the heck is a 15 fx svho faster than a 15 fzr???
    #4 is the gay spray adequate for dedicated cooling line to fizzle?
    #5 anyone tried the r&d water cooled housing?


  2. #2
    silver93t's Avatar
    Join Date
    Jun 2012
    Location
    NJ
    Posts
    1,073
    +1
    50
    1. Macc Racing are probably the largest and most aggressive. I first had the Riva sponsons which were pretty good, and these are even better. The stock sponsons are terrible in my opinion. The ski just spins out on tight turns.

    2. I'm pretty sure any wheel bigger than that will need a fpr. Check your afr.

    3. The should be very close but the FX hull is a bit better in rough water.

    4. I use it for the oil cooler but it should work fine. You may want to add a strainer. I would do what fizzle recommends though.

    5. Don't feel it's needed unless you run a big boost wheel.

    On a side note where do you ride? I'm usually in Raritan or Mantoloking Bay, Seaside, or the GWB.

  3. #3
    rcab85's Avatar
    Join Date
    Nov 2011
    Location
    lavalette, New Jersey, United States
    Posts
    1,612
    +1
    84
    well before I ditched the witch I was in lavalette by seaside bridge and hitting up the house for drags but I work in manasquan and ride that pretty often. I'm down to ride whenever.

  4. #4
    @JC's Avatar
    Join Date
    Sep 2012
    Location
    The Peoples Republic of Minnesota
    Posts
    2,032
    +1
    1,340
    Quote Originally Posted by rcab85 View Post
    couple of questions here gurus
    question #1 what are the best sponsons for 09-13 fzr?
    #2 best boost wheel no rrfpr? have c1 now need more.
    #3 how the heck is a 15 fx svho faster than a 15 fzr???
    #4 is the gay spray adequate for dedicated cooling line to fizzle?
    #5 anyone tried the r&d water cooled housing?
    See my sig for a good setup...

    1. The R&D sponsons work great on my FZS, the RIVAs suck period.
    2. The ET LB wheel is safe as long as you're not spinning over 8400. If you spin above that you'll probably need an RRFPR.
    3. ...
    4. No, plumb a new cooling line for your Fizzle. Buy these parts http://www.4-tecperformance.com/inde...oducts_id=1399 http://www.4-tecperformance.com/inde...oducts_id=1163 http://www.4-tecperformance.com/inde...oducts_id=1121 along with the VXR 3way splitter part# 60E-12581-00-00 to get rid of the stock 4 way splitter between the oil cooler and IC and buy some Gates 28439 Green Stripe Heater Hose to run as your new line to the IC. Note that you can do without the 3rd item the new bypass fitting (pisser) if you want to run the exit line from the IC to the stock right side pisser. I just used an inline coupler to connect the green stripe hose coming out of the IC to the hose already attached to the pisser. Works perfectly. Also consider adding a http://www.4-tecperformance.com/inde...oducts_id=1432 inline between the pump strainer and the IC to avoid plugging it up.
    5. Don't see the need unless you're going with big boost.

  5. #5
    Slamdcoop0428's Avatar
    Join Date
    Aug 2014
    Location
    Cape Coral, FL
    Posts
    1,004
    +1
    253
    et 15.5 with supporting mods! You'll be saying svho what?

  6. +1 by:


  7. #6
    rcab85's Avatar
    Join Date
    Nov 2011
    Location
    lavalette, New Jersey, United States
    Posts
    1,612
    +1
    84
    I have already r&d dual cooling, I blocked off the one going to the i/c and ran a dedicated to the i/c off the gay spray but I can tell it's not enough. also what did you do for 1/2 inch line out?

  8. #7
    rcab85's Avatar
    Join Date
    Nov 2011
    Location
    lavalette, New Jersey, United States
    Posts
    1,612
    +1
    84
    Lol ok so what are the supporting mods for that crazy wheel. I already the a/f guage and r&d bung but it's not installed.

  9. #8
    rcab85's Avatar
    Join Date
    Nov 2011
    Location
    lavalette, New Jersey, United States
    Posts
    1,612
    +1
    84
    ok got it for the pisser thanks.

  10. #9
    Ski Hacks MG's Avatar
    Join Date
    Apr 2013
    Location
    Georgia
    Posts
    5,251
    +1
    991
    Quote Originally Posted by @JC View Post
    Quote Originally Posted by rcab85 View Post
    couple of questions here gurus
    question #1 what are the best sponsons for 09-13 fzr?
    #2 best boost wheel no rrfpr? have c1 now need more.
    #3 how the heck is a 15 fx svho faster than a 15 fzr???
    #4 is the gay spray adequate for dedicated cooling line to fizzle?
    #5 anyone tried the r&d water cooled housing?
    See my sig for a good setup...

    1. The R&D sponsons work great on my FZS, the RIVAs suck period.
    2. The ET LB wheel is safe as long as you're not spinning over 8400. If you spin above that you'll probably need an RRFPR.
    3. ...
    4. No, plumb a new cooling line for your Fizzle. Buy these parts http://www.4-tecperformance.com/inde...oducts_id=1399 http://www.4-tecperformance.com/inde...oducts_id=1163 http://www.4-tecperformance.com/inde...oducts_id=1121 along with the VXR 3way splitter part# 60E-12581-00-00 to get rid of the stock 4 way splitter between the oil cooler and IC and buy some Gates 28439 Green Stripe Heater Hose to run as your new line to the IC. Note that you can do without the 3rd item the new bypass fitting (pisser) if you want to run the exit line from the IC to the stock right side pisser. I just used an inline coupler to connect the green stripe hose coming out of the IC to the hose already attached to the pisser. Works perfectly. Also consider adding a http://www.4-tecperformance.com/inde...oducts_id=1432 inline between the pump strainer and the IC to avoid plugging it up.
    5. Don't see the need unless you're going with big boost.
    This.

  11. #10
    rcab85's Avatar
    Join Date
    Nov 2011
    Location
    lavalette, New Jersey, United States
    Posts
    1,612
    +1
    84
    Lol having a bad day sorry guys

Page 1 of 2 12 LastLast

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Another XSPOWER Intercooler Setup *Updated Results*
    By 1FastTrespiper in forum 4-Tec Performance
    Replies: 53
    Last Post: 04-23-2006, 09:16 PM
  2. How many of you wear a helmet for recreational riding ?
    By Kinchyle in forum Sea Doo Open Discussion
    Replies: 7
    Last Post: 03-31-2006, 09:26 PM
  3. Lemoine NOPAS Setup RXP/RXT
    By mrracing in forum 4-Tec Performance
    Replies: 16
    Last Post: 12-06-2005, 06:14 PM
  4. What's the good pump setup for a stock 03 GTX-SC?
    By Jarrett in forum 4-Tec Performance
    Replies: 10
    Last Post: 07-15-2005, 05:17 AM
  5. Would this be an ok mod setup for a budget????
    By kenshin89 in forum 4-Tec Performance
    Replies: 13
    Last Post: 05-25-2005, 07:08 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •