Results 1 to 9 of 9
Thread: Hull/aluminum plate damage
-
07-26-2015, 09:35 AM #1
Hull/aluminum plate damage
Noticed this while inspecting the hull...
The bunks are placed in a position which makes me believe it got damaged from them. But what should i do about it?
Will warranty cover this? I definitely wont let the dealer have it for the rest of the summer, so i will take it in for repair off-season.
-
07-26-2015, 09:47 AM #2
looks like it'll come off with a lil elbow grease...
not deep at all.
-
07-26-2015, 02:14 PM #3
??
Look at the plastic piece on the heat exchanger. Its "bent" out of position
-
07-27-2015, 01:14 AM #4
They normally sit a bit recessed... No stress... Go have a look at some at a dealership
-
+1 by:
-
07-27-2015, 10:16 AM #5
Mine looks the same. Theres also alot of space around the part.
-
07-27-2015, 11:15 AM #6
-
07-28-2015, 10:01 AM #7
-
07-28-2015, 01:07 PM #8
what scratch are you looking at? the white mark I have on mine as well I thought it was a mark from the factory for assembling
-
07-28-2015, 03:16 PM #9
My spark has those white marking lines all over it! On the hull, jet pump, IBR, the engine and pretty much everywhere. I agree with you, it must be some assembling stuff...
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
S3 hull ride plate
By TDR in forum 4-Tec PerformanceReplies: 1Last Post: 07-23-2012, 09:12 AM -
Hull Id Plate
By Lvnspeed in forum Yamaha PWC Performance (2-stroke)Replies: 7Last Post: 05-05-2009, 04:35 PM -
Hull Damage repair cost
By RXPNJ in forum Sea Doo Open DiscussionReplies: 4Last Post: 06-14-2006, 07:07 PM -
repair hull damages black/green RXP 04
By xdsl in forum Sea Doo Open DiscussionReplies: 6Last Post: 05-04-2006, 05:22 PM -
Sever Hull damage, what should be done?
By ccassone in forum Sea Doo Open DiscussionReplies: 28Last Post: 02-06-2006, 11:48 PM
9 out of 10 times those speed wheel mounting screws will not come out/off...
Help needed: impeller housing...