07 GP1300R water line routing?

[silver93t]

Anyone have a good picture of the water line routing for an 07 gp1300r? I took the ski apart last fall and a few of the labels I put on the hoses fell off. Here are the lines I have in question:

The starboard side pisser hose. I have about a foot and a half section coming off the pisser. Where does the other end connect?

The plastic fitting that has the duckbill drain valve that mounts in front of the battery box on the starboard side. What hose goes to the forward facing nipple?

On the exhaust section behind the catalytic converter/dplate, there is a large nipple facing back and down. What hose goes there?

I can post pics tomorrow.

[WFO]

The starboard side pisser hose. I have about a foot and a half section coming off the pisser. Where does the other end connect?
top of U pipe

The plastic fitting that has the duckbill drain valve that mounts in front of the battery box on the starboard side. What hose goes to the forward facing nipple?
bilge siphon
one end goes to a white box under the intermediate shaft
other end goes to the transom thru hull port side second from the bottom

On the exhaust section behind the catalytic converter/dplate, there is a large nipple facing back and down. What hose goes there?
water exit hose from top rear of stinger to transom thru hull starboard side

[silver93t]

Wfo got a pic? I dont see a nipple on top of the u pipe. Just the fitting on the rubber exhaust coupler before the cat/dpate

[Prism]

If you run your hand from the rubber coupler connector in front of the d-plate forward, its about a foot away and faces forward. Its not sticking up but sticks forward. Starboard side of u pipe just as it starts the u shape about a foot to a foot and a half away from the rubber coupler facing forward near the top.

[silver93t]

Thanks guys. I'll look tomorrow when I get back to the shop. Been too long since I had this thing apart.