Results 1 to 3 of 3
Thread: 2010 TX to 2012+ pump
-
07-20-2015, 05:55 PM #1
2010 TX to 2012+ pump
Anyone have a parts list for the swap? Plate, pump, etc.
-
07-20-2015, 06:24 PM #2
-
07-21-2015, 05:30 AM #3
Look ok the parts microfiche for a 2012
You need:
Shoe
Studs
Washers/nuts for both sides of the studs
Ride plate
Complete pump
O rings & green reducer for between pump to shoe
Then block off the side thurhull fitting where the 2010 pump is currently feeding.
Your best bet is to get 2 pump shows. Hack off all the fittings to make it flat so it can sit flush against the hull. I used spray paint and painted the holes then removed the hacked shoe. Using the paint marks, I start drilling and grinding away for the thru fittings
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Fitting the 2012+ pump in the 2010 RXT-X
By Ski Hacks MG in forum 4-Tec PerformanceReplies: 8Last Post: 11-09-2015, 08:19 PM -
FS 2010 TX - 2012 PX Parts Sale
By Glade Rider in forum Sea Doo ClassifiedsReplies: 53Last Post: 08-21-2015, 02:23 AM -
Time to rebuild charger 2010 TX- Mod options
By swlamarshrunner in forum 4-Tec PerformanceReplies: 6Last Post: 05-20-2015, 01:09 PM -
Has anyone ?? 2012 pump on 2010 rxtx
By pete71 in forum 4-Tec PerformanceReplies: 10Last Post: 04-09-2013, 09:07 AM -
How-To: Bilge pumps
By USS RXT in forum Sea Doo How To & FAQsReplies: 59Last Post: 03-16-2010, 10:02 PM
The best I could do was to get 2 bolts started. Maybe with some machine...
Riva ride plate FX holes not...