speed guesses. fizzle+ 14 jims cut

[rcab85]

09 fzr basically
r3/c1 with supporting mods and riva water box.
not hull ventilated except foam removed.
current with seat on 7980 @ 72-73 no shims r&d plate
so with fizzle and jims ff with hull venting
my guess 77@ 8400 prop is 13/22

[@JC]

Time for a bigger wheel!

[Ski Hacks MG]

With an R3 and 13/22, you will be turning 8650 or so which should put you up close to 79-80mph with the mods listed (incl. Fizzle/Jims/Venting). You really should grab a 2014 FZ plate to send to Jim.

[mikeFZR]

It will take some fine tuning of the prop, but R3/C1/IC should be right around 80. Check out the search because I've seen some 80mph skis on here with similar mods but with a stock wheel-- that might help give you an idea of what to expect.

[hdlefler]

With an R3 and 13/22, you will be turning 8650 or so which should put you up close to 79-80mph with the mods listed (incl. Fizzle/Jims/Venting). You really should grab a 2014 FZ plate to send to Jim.

+1

[Slamdcoop0428]

I did 79.4 in 83 degree weather with the stock wheel. You should easily be at 80+ with that wheel and mods. I also had the the fizzle and 14 cut plate by Jim to reach those speeds at the time. Hook a kana flex tube to your intake and let that thing rip. I also ran a stock prop unpitched from the factory. Never put a prop in until I went ET low boost.

[rcab85]

Yeah I sent 2014 fz Plate to Jim and ordered fizzle with fake Bov so I'm hoping the 1400 turns her into monster.
I'm very interested in a etlb but am worried about reliability and too high on my rpms

[Slamdcoop0428]

I'm running the ET 15.5 now with original clutch and completely stock motor. 100hrs , No valve train work doing 8700+ rpm. Let that thing eat!

[rcab85]

I'm at 98 hours now but how long do these motors last?

[Slamdcoop0428]

I'm at 98 hours now but how long do these motors last?

Hard to say. I put the ETLB wheel In at 40hrs. Then I switchef to the et 15.5 around 85hrs I think. Still running hard as hell.