BOV Adjustment..

[Rescue1]

I've read through a bunch of threads about the subject, but I couldn't find the exact procedure. If that info exists, I apologize..

Most of the threads say to turn the nut. I can get a wrench into the hose hole to hold the shaft, and another on the nut, but which direction will tighten the valve up? My guess in clockwise but wanted to see what everyone else has done. Thanks for the help.

[nicjak]

you will work it out by the tension it places on the valve, try pushing the valve in before and then after.

[Spooling]

This link should help you:

http://www.greenhulk.net/forums/showthread.php?t=187757

PS - I been meaning to ask - where is Sweetwater - somewhere in CA?

[jetdave56]

I use a block off plate but to test tighten the valve you will turn the nut that will simultaneously turns the bolt,when you turn the nut/bolt and and make it longer it will loosen the valve and make it leak as you see when I push in with a screwdriver(pic2) when you turn the other way and shorten all the way you will try again with a screwdriver and will see that you can't push the valve in (pic1)..

It's a tight as it's gonna be..