Results 1 to 4 of 4
-
07-14-2015, 11:01 AM #1
how do i install an impeller housing on a waveraider
This is probably an easy question for you all but my duct impeller was torn apart by a previous owner so i had to order a replacement. i received the new one with bearings and all installed on it. As i want to sliding it over the end of the drive shaft it wouldn't fit over the thicker end of the shaft. The part is the correct part for my 95 waveraider 700 deluxe. I really have no idea on how to install it.
part number- 62T-51315-00-94
Photos of old housing
photos of new housing and current drive shaft
-BrandonLast edited by brando785; 07-14-2015 at 01:42 PM.
-
07-14-2015, 06:48 PM #2
I'm not sure, Maybe put the shaft in the freezer
-
07-15-2015, 11:59 AM #3
- Join Date
- Jul 2014
- Posts
- 122
- +1
- 2
I believe it is supposed to be a press in fit. You will need a press. To be 100% sure do measure the bearing ID and the shaft OD.
-
07-15-2015, 10:02 PM #4
Like trasti mentioned, it is a press fit. You really should get a pump rebuild kit and change all the bearings and seals while you are at it.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
How do I install the main relay on an aquatrax
By Mati in forum Honda How To & FAQsReplies: 1Last Post: 07-02-2015, 08:53 PM -
how do you install an oil injection block-off plate on a 97 stx 1100
By suzuki4444 in forum Kawasaki PWC Performance (2-stroke)Replies: 1Last Post: 05-09-2013, 09:49 AM -
How do I install new impeller
By race24x in forum 4-Tec PerformanceReplies: 3Last Post: 06-21-2011, 09:02 AM -
how do i install a boost gauge on a 03 gtx?
By FL03GTX in forum 4-Tec PerformanceReplies: 0Last Post: 08-20-2007, 03:00 PM -
how do i install a boost gauge on a 03 gtx?
By FL03GTX in forum 4-Tec PerformanceReplies: 1Last Post: 08-20-2007, 02:26 PM
I think the crankshaft is the main component needed to change the stroke...
FZR-R3 Turbo build