Results 1 to 1 of 1
Thread: Drive shaft install confirmation
-
07-13-2015, 08:38 PM #1
Drive shaft install confirmation
First time re-installing the drive shaft on my RXP, looking for confirmation that I got it in far enough. There was a tiny grove in the shaft, which I think the manual uses as the indicator, which is no longer visible. I think it's good but want to confirm, can't spin the shaft so the splines must be engaged.
Also, I was replacing the bellow parts, top hat/cclip/boot/carbon, and wonder how loose the cclip is supposed to be on the shaft? I got a new one, it went on pretty tough but once on I could spin it by hand around the shaft before the top had was released onto it. Is this normal?
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
2006 rxt drive shaft installation
By fhydro in forum 4-Tec PerformanceReplies: 3Last Post: 04-16-2012, 08:36 AM -
Drive shaft install
By monaroman76 in forum 4-Tec PerformanceReplies: 7Last Post: 01-20-2012, 08:32 AM -
Installing drive shaft, can't get PTO seal flush... Need Help!
By GTLaser in forum 4-Tec PerformanceReplies: 2Last Post: 05-27-2011, 01:31 PM -
Skat Trac/Rad 4 Drive shaft seal install
By RXP-REX in forum Sea Doo How To & FAQsReplies: 2Last Post: 05-05-2010, 04:12 PM -
Through hull drive shaft seal how to install
By BlackHawk in forum 4-Tec PerformanceReplies: 6Last Post: 10-11-2008, 04:49 PM
Basic thermal dynamics, need that balance for the proper heat exchange. ...
Pressure relief valve after...