Steering assist override?!?!?!

[mattman87]

So I absolutely hate the steering assist on my 2014 rxp x 260. Im just not used to it / brought up that way... I had a very close call not with almost colliding with another ski because I turned and it gave throttle and pushed me into his way! Is there any whey to deactivate this feature even if it requires buying a tuner? I do not want to dig into it and snip the wires and have a check engine light but I will if there is no other option...

[GoneRXT]

I hate mine to ! Id like to know the same thing just don't want to hack anything up or check engine/otas lights

[mattman87]

Dose anyone have a electrical schematic diagram for these skis? I wonder if I could just find the right size resistor and put it in line of the steering assist to bypass it...

[EVN81]

Remove the magnet on the steering column so the sensor is not triggered anymore

Item 68

http://partsfinder.onlinemicrofiche....-STEERING-ASSY.

[mattman87]

I don't see the magnet on the drawing or "item 68" on the parts list.. where are you finding this?

Remove the magnet on the steering column so the sensor is not triggered anymore

Item 68

http://partsfinder.onlinemicrofiche....-STEERING-ASSY.

[skidoochris]

come on guys everyone needs a ski that thinks its smarter than the driver...

[EVN81]

At the part finder the named it the "OTAS ACTUATOR":

But here you go:



More info: http://www.brpmanuals.com

[mattman87]

Thanks for the input guys! I will give this a try some night

[mattman87]

After a year I still hate the surprise auto throttle when turning the bars, so today I attempted to remove the magnets but to pull the steering column out I would have to drill a few aluminum rivets out but I did not want to go that route. I did find the plug. It has three wires. After removing it the o.t.s.a. light comes on along with a sounded alarm. Any one have a wiring diagram of this ski? I must be able to splice two wires together and leave the third one open (sensor input wire). Any thoughts?

[EVN81]

After a year I still hate the surprise auto throttle when turning the bars, so today I attempted to remove the magnets but to pull the steering column out I would have to drill a few aluminum rivets out but I did not want to go that route. I did find the plug. It has three wires. After removing it the o.t.s.a. light comes on along with a sounded alarm. Any one have a wiring diagram of this ski? I must be able to splice two wires together and leave the third one open (sensor input wire). Any thoughts?

It´s a long time ago but I certainly did not drill out any rivets !!
If I remember correct I removed the front plastic and after the cluster itself (unpugged it).
The steering column was half out as it was lying on the glovebox.
This was on a X-model ski