Results 1 to 5 of 5
  1. #1
    3ftDeep's Avatar
    Join Date
    Mar 2014
    Location
    White Rock, BC
    Posts
    381
    +1
    112

    How to Perform iTC and iBR Levers Lubrication on a Sea-Doo

    Step-by-step instructions for lubricating the iTC and iBR levers on your Sea-Doo. Part of the 100 hour service for all Sea-Doo personal watercraft with intelligent Brake and Reverse, and intelligent Throttle Control systems, doing this relatively simple procedure yourself can save you a lot of money.
    If you like your videos, please Subscribe!



  2. #2
    JT jpt7779's Avatar
    Join Date
    Jul 2008
    Location
    Pittsburg, Texas Lake Bob Sandlin
    Posts
    4,021
    +1
    779
    Nice job.

  3. #3
    Ski Hacks MG's Avatar
    Join Date
    Apr 2013
    Location
    Georgia
    Posts
    5,251
    +1
    991
    Thanks for the vid. That is some strange looking XPS synthetic grease.

  4. #4
    This is how I run a jetski shop in the desert nmpeter's Avatar
    Join Date
    May 2008
    Location
    Elephant Butte New Mexico
    Posts
    7,544
    +1
    1,806
    Where can I get that special seadoo wrench to remove the ignition post nut?

    I sell a surprising number of those....

    In regards to the grease, BRP requires a license fee in order to show their products in use on a youtube video.

    Permatex digs the free advertising

  5. #5
    EVN81's Avatar
    Join Date
    Jul 2013
    Location
    Terschelling - the Netherlands
    Posts
    514
    +1
    43
    Nice video but maybe it's was also good to explain how to remove the TAS.

    How to disconnect the electrical plugs from the TAS and also the big connector under the steering column.

    And check for moisture inside on the connections and after clean / dry them.

    All to prevent fault code P060D

    http://www.greenhulk.net/forums/showthread.php?t=187584

    BTW spray the inside of the IBR levers after EVERY ride generally with XPS lube spray (especially when you're in salt water)

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. How To Perform iTC and iBR Levers Lubrication on a Sea-Doo
    By 3ftDeep in forum Videos & Pictures
    Replies: 0
    Last Post: 07-02-2015, 07:05 AM
  2. how to remove the reverse cable lever to get room for ic removal and installation
    By peterj59 in forum Yamaha PWC Performance (4-stroke)
    Replies: 3
    Last Post: 11-18-2011, 08:34 PM
  3. newbie how to...perform a prepurchase inspection
    By jeepnjon in forum 4-Tec Performance
    Replies: 1
    Last Post: 06-25-2007, 09:22 AM
  4. Need help with how to pull pump and clean
    By Coleybear in forum Sea Doo Open Discussion
    Replies: 28
    Last Post: 05-24-2007, 06:09 PM
  5. How to center head and head gasket
    By LT1GMC in forum Yamaha PWC Performance (2-stroke)
    Replies: 0
    Last Post: 04-21-2007, 08:17 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •