2014 fzs issue wont go past 40

[JDELFINO]

have a 2014 fzs wont got past 40mph or 5000 rpms no check engine light and no limp mode light.

wondering if anyone has had the same issues the ski only has 32 hours on it doesnt make sense. looking forward to your response.

[SOV]

Hi,
Check your supercharger,looks like you have no boost at all. The sc wheel should spin in one way only, only a hose to take off.
Sorry for my bad english.
Sergiu

[Ski Hacks MG]

More than likely one of two things.

1. Ski is in Learner mode.

2. Supercharger clutch failed. Remove intake boot from front of supercharger, reach in and spin the wheel by hand and see if it spins both ways. If it does, sprag clutch is gone.

[mikegp]

More than likely one of two things.

1. Ski is in Learner mode.

2. Supercharger clutch failed. Remove intake boot from front of supercharger, reach in and spin the wheel by hand and see if it spins both ways. If it does, sprag clutch is gone.

agreed with you on the first one , don't agree on the second one [ white boy ] have seen a clutch spin one way w/o any load and slip under a load [white boy ]

[Ski Hacks MG]

It's still the most logical place to start, crazy mexican. And if the wheel spins both ways, the clutch is done, just like I said.

[Timdog]

My clutch just went same thing happened, as ccw says take filter off if spins both ways the clutch is shot, but as its a 2014 it's should be a warranty job

[mikegp]

It's still the most logical place to start, crazy mexican. And if the wheel spins both ways, the clutch is done, just like I said.

that's it calling your wife now !!! got insulted !!! .
but i agreed on the logical side .. lmao ....

[Ski Hacks MG]

I also didn't think the 2014 clutch was prone to failure like the old clutches were but anything is possible.

[2fast4u]

check to be sure the reverse lever is all the way down! How many rpms can you turn now? usualy if the reverse lever switch is ativated you can only get 3500 rpms when sc clutch is bad or hose is off sc max rpms is usualy 5000-5500. Tommy Jordan

[JDELFINO]

thanks for the info i was able to figure it out shes running good. only scary thing is two cylinders have a little over 90 psi and the other two have a little over 110psi. doesn't make sense with such low hours