Results 1 to 8 of 8
-
06-14-2015, 06:17 PM #1
- Join Date
- May 2012
- Location
- Ontario, Canada
- Posts
- 52
- +1
- 1
What is required at 100hr service - 2012 - RXTX 260
Hi there,
what is required for the 2012 RXTX 260 100 hour service? I get conflicting information with regards to the need to rebuild the supercharger???
help please
-
06-14-2015, 06:30 PM #2
you dont have to do shit
you can run the SC until it explodes
they are just recommendations
a few facts.... the SC spins at about 48000 rpm
it has tiny bearings that are not really rated for that high of rpm
last if the SC fails it will be a very expensive repair bill
and it may destroy the motor
sure BRP now says the SC is good to 200 hours
but still uses the same parts that they used to say needed a rebuild at 100hours
remember the higher you spin the motor the faster the tiny SC bearings spin
-
+1 by:
-
06-14-2015, 07:33 PM #3
On my '12 GTX 215 the SC was rebuilt at 225 hrs. My mechanic said old parts were still in good shape, no visible wear. No mods on the ski, didn't beat the crap out of it, lots of two up cruising. I would consider rebuild sooner on a modded and ridden hard ski.......
-
06-14-2015, 07:48 PM #4
I would change the oil & plugs, lube any moving parts ( throttle body, steering, reverse gate etc, with Seadoo Lube ) and pull the SC and have it rebuilt.
-
+1 by:
-
06-14-2015, 07:53 PM #5
What he ^^^^^^^^^said.......
-
06-20-2015, 08:23 PM #6
I have some friends with 300h on theire 215hp and they never rebuild theire sc, but i think its not ŕ good idea, my dealer say to me to rebuild it ŕ 100h (i have a 260 rxpx)
You have to know that the sc need to be rebuild every 2 years (brp said this)
-
06-20-2015, 08:31 PM #7
2 years or 100 hours.....
-
06-22-2015, 07:00 PM #8
Friction sleeves on the IBR are recommended at 100 hrs. While IBR is out might as well pull pump cover and inspect bearing for contamination, add grease, could pull pump and change wear ring if not done recently....
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
What is required to convert XLT over the the newer HO pump?
By thetolleyman in forum Yamaha PWC Performance (2-stroke)Replies: 27Last Post: 09-09-2019, 10:29 PM -
2012 rxtx 260 air intake
By beachboy66 in forum 4-Tec PerformanceReplies: 1Last Post: 05-26-2014, 10:39 PM -
What is the max RPM of a RXT 260?
By rxt260_IS in forum Sea Doo Open DiscussionReplies: 12Last Post: 03-19-2013, 07:33 AM -
What is the diameter of the 2012 speedster rack
By hancop in forum Sea Doo Sport BoatsReplies: 0Last Post: 09-30-2012, 04:00 PM -
what is the best price for RXT X 260?
By XRIDER in forum Sea Doo Open DiscussionReplies: 4Last Post: 03-22-2010, 02:36 PM
History: Ski came with busted motor (rebuilt) Inside Hull...
Kawasaki 15f sudden hard cranking...