Rub rail pisser?

[Speedjunky64]

So I recently found a small hose laying in the battery compartment.
Followed it and saw it was attached to a pisser underneath the right side rub rail near the back.
The other end wasn't attached to anything so not certain where it goes.

This is on a 2010 RXTX with a Riva gen3 IC
I believe it should connect to the IC, but not certain.

Looked up the SD micro fiche but could not find any details on that pisser.

Any clues?

[Xspook]

I'm not familiar with your model, but sounds like a battery vent hose to me. If you have an AGM battery, no venting is needed.

[Speedjunky64]

Ha, make sense!
Yes, AGM battery so will leave it as is.
Thanks!

[Hrly6816]

Could this port be used for the intercooler? When I upgraded my intercooler the dealer told me I could just cap it off.

[Sanfish]

Could this port be used for the intercooler? When I upgraded my intercooler the dealer told me I could just cap it off.

No. The battery vent is located forward starboard (as mentioned above).

The IC relief is located port rear. As for "capping it off"...If aftermarket okay, if factory replacement I would not.

[stuckmoto]

That is the stock battery vent on the 2010. It has a check valve going through the hull. Just cap it.

[Speedjunky64]

That is the stock battery vent on the 2010. It has a check valve going through the hull. Just cap it.

Thanks!
Already done!