Results 1 to 6 of 6
-
05-25-2015, 03:47 PM #1
- Join Date
- Mar 2010
- Location
- Holland PA
- Posts
- 239
- +1
- 2
2008 rxpx hard start and grinding.
Posted a thread earlier, rxpx 81 hours wouldn't start. Found the front cylinder to have good compression middle to have 30psi less and back to have no compression. Took the motor apart, Pistons head excetra all looked good. Replaced the head gasket and ski fired right up. Took it to the water to water test and hard start/slow cranking started again. Replaced the battery, starter and starter selinoid and still doing the same thing. Sometimes kicks over but when running has a grinding metal noise coming from the rear of the motor. Any idea what could be causing the grinding and the slow cranking?
Thanks
drew
-
05-25-2015, 05:48 PM #2
Your supercharger bearings any good? That can even lockup the motor when it fails / siezes
-
06-01-2015, 10:28 PM #3
- Join Date
- Mar 2010
- Location
- Holland PA
- Posts
- 239
- +1
- 2
yep supercharger was taken off and checked and is good to go
-
06-02-2015, 06:12 AM #4
Did you check the pump when it was out?
-
06-02-2015, 06:55 PM #5
- Join Date
- Mar 2010
- Location
- Holland PA
- Posts
- 239
- +1
- 2
motor just pulled next step is to check the pump and back of engine as well as the shaft
-
05-10-2020, 12:10 PM #6
- Join Date
- May 2019
- Posts
- 8
Anyone know what the issue was?
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
96 HX Hard Starting and Doesn't REV up very fast?
By shkdwn387 in forum 2-Stroke PerformanceReplies: 2Last Post: 03-22-2012, 08:14 PM -
FS 2008 RXPX stock springs and retainers, 5 hrs
By vspec1 in forum Sea Doo ClassifiedsReplies: 0Last Post: 07-30-2011, 05:28 PM -
1999 Genesis FICHT hard start and other issues
By Engineer in forum Polaris How To & FAQsReplies: 5Last Post: 06-25-2010, 04:58 PM -
1997 SPX hard start and sluggish
By Andrerichard in forum Sea Doo Open DiscussionReplies: 1Last Post: 08-23-2009, 07:57 PM -
96 SLX780 Rough Idle, Hard Start, and Miss
By rickreeves1 in forum Polaris Open DiscussionReplies: 23Last Post: 02-27-2008, 06:43 PM
Transom plate reseal