Results 1 to 10 of 11
Thread: Et 127 install
-
05-18-2015, 07:53 PM #1
Et 127 install
Need some help before I install. My charger has about 28hrs on it. So can I just take the front cover off and pull the wheel nut, install new wheel. Tq and install?
-
05-18-2015, 07:55 PM #2
-
05-18-2015, 10:14 PM #3
Reset slip to 13lb cold charger so when hot will settle to 11-12lb slip
-
-
05-19-2015, 11:19 AM #4
Let me know if you need help with the slip. Checked mine at about 30hrs and it was down. Tried a bunch of spring washer configs to finally find one that came out well. Can send you what config I used.
-
05-20-2015, 11:48 PM #5
-
05-21-2015, 04:34 AM #6
I would not torque the factory bolt more than spec . 15 for slip is a little high for this charger. I have a spare charger that's junk that I use to try different slip configs but one thing you have to consider is that you should check all washers thickness before you use. Some seem to be a little difference in thickness than others so whatever works to get that slip is what you need
-
05-21-2015, 05:43 AM #7
-
05-21-2015, 09:01 AM #8
Sno gave me a bunch of different spring washer set ups. Tried a coupld til the slip was right. Would do that before adding any shims.
-
05-21-2015, 11:42 AM #9
How fast should I go with this wheel and 15/20 prop? Only mod is riva intake
-
05-21-2015, 07:32 PM #10
Riva air intake? It's not that great. 4" air, 127 wheel and 42's, 72-74ish pending other factors.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Excessive vibration from Kanaflex after ET 127 install
By surferd15 in forum 4-Tec PerformanceReplies: 10Last Post: 12-19-2014, 04:10 AM -
Riva S3 vs ET 127
By h2jim in forum 4-Tec PerformanceReplies: 13Last Post: 04-26-2012, 01:03 PM -
ET 127 : 215 Dropin wheel 3mm spacer Billet impeller?????
By WBoulton in forum 4-Tec PerformanceReplies: 44Last Post: 02-28-2012, 02:06 PM -
WTB ET 127 or SDC A Kit R or Rotax Racing 127mm w/spacer or S3 w/ front housing
By cosmic in forum Sea Doo ClassifiedsReplies: 3Last Post: 07-11-2011, 08:23 AM -
Riva S3 vs ET 127
By h2jim in forum 4-Tec PerformanceReplies: 0Last Post: 10-19-2010, 05:47 PM
for sure. The fizzle 500 is actually a good intercooler. It’s perfect for...
Riva Tune Question - 2015 FZR with...